ASSEMBLY INSTRUCTIONS
PACKAGE CONTENTS
Shelfx 6
B
x 48 +2 extra
Tapered Lock
D
6-Tier Wire Shelving Rack
A
G
H I
x 8
Bottom Pole
x 8 Top Pole
F
B
G
A
I
D
A
A
A
H
G
G
Warning:
Maximum weight capacity per shelf is
250lbs when weight is equally distributed.
Do not overload.
Failure to follow these instructions may
result in serious injury or death of
yourself and people around you.
Some of the part are heavy and/or has
shape edge, please install it carefully to
avoid hurt you and people around you.
Only one unit can be stacked on top of
another unit.
Stacking more than one unit will cause
the rack to tip over.
Caution:
Do not stand on or climb on the
shelving unit.
Place heavier items on lower shelves
and lighter ones on top shelves.
(with pole cap and pole
connector preassembled)
(with D and I installed)
F
3. Turn assembly upright and push the shelf (A) firmly onto
the tapered locks (B). Note: Make sure the lip of shelf (A)
is facing down and the levelers (D) on bottom poles (G)
are on the floor.
4. Repeat steps 1-3 for the second shelf (A).
2. Rest shelf (A) on its side, then insert the bottom poles (G)
through the corner holes of the shelf (A).
5. Screw top pole (F) onto bottom pole(G), hand tighten.
6. Repeat steps 1-3 for the remaining shelf.
7. Stack Another Unit On Top as 6 Shelf Wire Shelving Rack
(Optional)
a. Remove the pole cap (H) from top of the top pole (F) of the
first unit.
b. Remove feet leveler (D) and screw pole insert (I) from bottom
of bottom pole (G) of second unit.
c. Screw pole connector (E) into top poles of first unit and bottom
poles of second unit.
d. Repeat steps 4-6 for the remaining shelves to assemble unit
as 6 shelf wire shelving rack.
C
x 8 Connector
E
x 4 Extra Connector
Use it to assemble as
6 Tier Wire Rack
(may be already
attached to F or G)
Feet Leveler
(may be already
attached to G)
x 8
1. With the tapered end facing up, snap the two halves of a
tapered lock (B) at the desired height on bottom pole (G).
Repeat for the remaining bottom poles (G), making sure
the tapered locks (B) are installed at the same grooved
line on each bottom pole (G).
Threaded insert
(may be already attached to G)
x 8
Pole Cap
(may be already attached to F)
x 8
http://www.paylesshere.com
XF-6TWS1424
J
x 20 Black plastic spacer
(NOTE: Discard the black plastic spacers J.
These between each shelf are only for packing
purpose , not for assembling.)
/
