Page is loading ...
Scan the QR code with your mobile device or follow the link
for helpful videos and specications related to this product.
https://vivo-us.com/products/desk-top2w
SKU: DESK-TOP2W
59”x 27.6” Three-Section Tabletop
Instruction Manual
2 3
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualied technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
PACKAGE CONTENTS
Phillips
Screwdriver
TOOLS NEEDED
WARNING!
B (x2)
Desktop Side
A (x1)
Desktop
Center
C (x2)
Support Bar
D (x8)
M5x12
ASSEMBLY STEPS
STEP 1
Lay Desktop Center and Sides (A, B) upside down on a at surface and slide together,
ensuring bevelled edges are aligned.
STEP 2
Make sure all sections are sitting completely at before continuing.
STEP 3
Assemble Support Bars (C) to Desktop using M5x12 Screws (D). Insert the four center screws
rst, then insert the side screws and tighten all with a Phillips screwdriver.
HOW TO INSTALL A TABLETOP
1. Place desktop on frame and make sure
everything is aligned in the desired
position.
2. Drill 1/8” to 1/4” deep pilot holes. Use a
7/64” bit for the desktop mounting screws,
and a 3/32” bit for the crank/controller
mounting screws (if needed).
3. Tighten screws into desktop. Do not
overtighten, as this could strip the holes
and reduce the overall strength of the
assembled desk.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Last Updated: 1/11/2019
If any parts are received damaged or defective, please contact us. We are happy to
replace parts to ensure you have a fully functioning product.
For more VIVO products, check out our website at:
www.vivo-us.com.
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
/