Rod Desyne DVD28C Installation guide

Installation Instruction for Room Divider Track

TRACK ASSEMBLY:

1. Slide the end cap into one end of a track piece and tighten the screw till flush with the

track surface.

2. Sliding the hook carriers into the opposite open end of the track, ensure all hooks are

aligned in the same direction. If necessary, continue adding carriers into another piece of

track depending on tracks’ overall length.

3. Install the other end cap on the farthest end of overall track away from the carriers.

MOUNTING THE TRACK:

Screw the track directly to the ceiling, placing one screw through each of the pre-drilled holes

across the length of the track. Be sure that there is a screw within 6 inches of each end of the

track. With multiple track piece installations, ensure that each additional track piece is precisely

aligned with the next one, first to last, to complete the system. Additional holes may need to be

drilled in the flange of the track to complete your particular installation.

MOUNTING THE DRAPE:

1. Start hanging drape at either end cap. Slide the grommet of the curtain over the exposed

hook end, and continue to the next grommet repeating the procedure.

2. Each hook will be supporting a separate grommet all the way to the end of the drape at

the opposite end cap.

3. Remove any excess hook sliders if needed by loosening the screw and removing the end

cap and sliding them out of the track.

4. Replace the end cap ensuring not to over tighten the screw.

TECHNICAL SUPPORT: 1-866-326-1989