Velux VCE 3434 2004 FAQ

Brand: Velux

Model: VCE 3434 2004

Type: FAQ

1. What do I need to know about my roof before ordering a skylight?

o Roof pitch - to determine proper skylight, as curb mount requires 0 (flat) - 60

degree pitch

o Roofing material - for appropriate flashing, ECL - shingles (10 - 60 degree

pitch) or ECW - tile (14 - 60 degree pitch)

o Rafter spacing - 16” on center, or 24” on center (for example) to determine

proper skylight width

2. How do I determine which curb mount skylight size I should order?

o Outside curb dimensions, including flashing, is the correct way to determine

the curb mount skylight size you need. It’s very important to confirm your

curb dimensions before ordering.

3. Do I need to purchase flashing separately?

o Yes, VELUX curb mount flashing is required for the “No Leak” installation

warranty and it’s sold separately because the type of flashing you need

depends on your roof type. Please refer to bullet #1 to determine which

flashing model you need.

4. Can a curb mount skylight be installed on a flat roof?

o

Yes, VELUX curb mount skylights can be installed on a roof pitch anywhere

between 0 - 60 degrees. Please note: VELUX flashing kits can only be used

on a sloped roof.

5. Can I replace a plastic bubble skylight with a VELUX curb mount skylight?

o Yes, VELUX curb mount skylights are perfect for replacing plastic bubble

skylights, or any other curb mount skylight.

6. Do I need anything additional on the exterior to install this curb mount

skylight?

o In a new installation, you will need 2x4 or 2x6 lumber to build the roof curb

on which the skylight is mounted. When replacing an existing skylight, if the

curb is in good shape, then you may be able to re-use the existing curb, or

you can simply build a new one.

1

Velux VCE 3434 2004 FAQ

Brand: Velux

Model: VCE 3434 2004

Type: FAQ

Download PDF

Related papers

Other documents