ADTRAN DSU IV ESP User manual

Type
User manual

This manual is also suitable for

DSU IV ESP DATA SERVICE UNIT P/N 1204011L1
For more detailed documentation, visit us online at www.adtran.com
Quick Start Guide, 61204011L1-13A, June 2001 Technical Support 1-888-4ADTRAN (1-888-423-8726) Copyright 2001 ADTRAN, All Rights Reserved
10BaseT
LAN Card
VT 100 Terminal or device running
SLIP or async PPP protocol.
I
NSTALLATION
I
NFORMATION
An 8-pin Telco jack, a control port, a captive power cord and a power
switch are also located on the rear panel. See Rear Panel in Chapter 3,
of the DSU IV ESP User Manual for more information.
The rear panel contains two DTE connectors which provide V.35 or
EIA-232 interfaces. The configuration settings are found in Chapter 6 of
the DSU IV ESP User Manual.
The DSU IV ESP rear panel has two card slots for the installation of dial
backup and ethernet cards. See DBU and Ethernet Card Slots in
Chapter 3 of the DSU IV ESP User Manual for instructions on inserting
these cards.
Pinouts for connectors are listed in Appendix A,
Pinouts,
in the DSU IV
ESP User Manual.
Additional specific information can be found on the product CD which
contains the DSU IV ESP User Manual, FAQs, Data Sheets,
Applications, and White Papers.
R
EAR
P
ANEL
D
ESCRIPTIONS
DBU Interface ESP DBU card slot
LAN Interface ESP Ethernet card slot
Telco Connection Connection to dedicated circuit (DDS network)
EIA-232 Connector Connection to a DTE interface
Control
Connection to a VT 100 terminal or a device
running SLIP or async PPP protocol
V.35 Connector High-speed DTE interface
Power Switch Turns power on or off
115 VAC Connection Power cord connection
  • Page 1 1

ADTRAN DSU IV ESP User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI