GETTING STARTED:
Follow the instructions below to connect and power
on the set top box.
SCART-TV
LOOP OUT ANT IN
SCART-VCR
SCART-TV
LOOP OUT ANT IN
SCART-VCR
SCART-TV
LOOP OUT ANT IN
SCART-VCR
a
b
a
b
c
d
Take the antenna coax cable and connect it to the ANT
IN connector on the back panel of the set top box.
Connect a scart cable (not supplied) between the
SCART-TV socket on the back panel of the set top box
and the scart socket on your TV
Plug the mains lead into an available socket.
Insert batteries (AAA) into the remote control.
Ensuring the + and - marks match.
FIRST TIME INSTALLATION:
a
b
c
d
When connected correctly, the first time you
power on the set top box you will see the
above screen.
Use the
/ buttons to navigate up or down
and the / buttons to change the options.
When complete press the ENTER button.
To complete the installation use the /
buttons to select YES and then press the
ENTER button.
A channel search will begin automatically
and list the available stations. If multiple
transmitters are available, select from the pop
up menu using the
/ buttons, and press
ENTER.