NuvoH2O CitraPro RC2 Operating instructions

Brand
NuvoH2O
Model
CitraPro RC2
Category
Sanitary ware
Type
Operating instructions
877-688-6426 citrachargepro.com
CCP160126
INSTALLATION GUIDE
CitraChargePro
Spot-Free
Dishwashing
System
citrachargepro.com
877-688-6426
What to expect with
CitraChargePro
CitraChargePro usually requires signicantly less soap in your
dishwasher; please decrease the amount of soap used by
one half. Also, avoid using pre-soaks or rinse-aids. Using too
much soap or using rinse-aids may actually cause a ne
white lm or spots to form on dishes. This spotting can
also be aggravated by some of the no-phosphate dishwasher
detergents found in many states.
You can now enjoy clean, healthy, spot-free dishes without
the daily hassle and costs of traditional additives.
Welcome
Congratulations on your purchase of CitraChargePro; the
under-the-sink solution for spot-free dishes from NuvoH2O.
CitraCharge Pro uses a food-grade citrus formulation
(CitraCharge) to naturally condition your water for clean
dishes load after load after load – for up to three months
with a single cartridge. No more stuck-on food particles
and unsightly spotting.
This formulation was rst designed for the food services
industries in the early 1980’s and has been helping solve
complex water problems for some of the nation’s largest
businesses ever since. Re-engineered for your home, the
patent-pending process of CitraCharge Pro is uniquely
eective in preventing and removing hard water spotting
on your dishes and scale buildup from your dishwasher.
1
citrachargepro.com
877-688-6426
STEP 2
Collect needed tools and consumables
Determine what type and size connection currently connects
your dishwasher line to the shuto. You will need the following
connection supplies:
1 Connection Hose
A new line between the CitraChargePro system and your
dishwasher shuto. It will need to connect to your dish
washer shuto valve on one end and the CitraChargePro
on the other. It will need to be long enough to go from
the shuto valve to the location where you mount your
CitraChargePro System in your cabinet (see Step 3 below).
Braided stainless steel hoses are readily available at your
local DIY store in various lengths and connection types.
The most common length hoses are 20” long so the ideal
location to mount your CitraChargePro System would be
within 20” of the valve. But other length hoses are also
available. Note the size and type of the ttings you need to
connect to. The CitraChargePro System will be a very common
3/8” male connection. You also need to note the type of tting
where the hose attaches to your dishwasher shut-o valve.
Most often this will be a threaded 3/8” tting also but may
not always be.
Installation Guide
STEP 1
Identify the connection point
for the CitraChargePro System
The CitraCharge System is designed to be installed between
the dishwasher and it’s hot-water supply line (usually attached
to the hot water faucet line).
Find the dishwasher hot water supply line which usually will be
obvious as a water line going from a shuto valve under the sink
and then exiting the cabinet in the direction of the dishwasher.
The shuto valve that the line comes from is typically coming o
the hot water line to your sink faucet.
2 3
CitraChargePro
Spot-Free
Dishwashing System
citrachargepro.com
877-688-6426
[While the head can easily be reversed by unscrewing it
from the mounting bracket it is easier to get the head mounted
positioned correctly before you mount the bracket to the
cabinet wall.]
Ensure that the bottom of the System is above the oor of the
cabinet by at least 2” to allow clearance to remove the canister
body when it’s time to change the cartridge.
2 Teon Tape
A common consumable you can buy at your local DIY
store. All male threads should be wrapped with Teon tape
before connecting.
3 Adjustable Wrench
4 Drill with a small (1/8”) bit
To create starter holes in your cabinet for the screws that will
hold the CitraChargePro System in place.
5 Phillips head screwdriver
To drive the screws which hold the CitraChargePro System
in place.
STEP 3
Mount the CitraChargePro System
Mount the CitraCharge canister to the side or back wall of the
cabinet beneath the sink and between or adjacent to the hot
water supply line.
Make sure the canister is mounted level and close enough to
connect to the hot water supply line.
Please note the “IN” and “OUT” notations on the System head.
The “IN” side should be closest to your dishwasher shut-o
valve and the “OUT” side closest to the dishwasher.
4 5
FIG. 1
citrachargepro.com
877-688-6426
STEP 5
Connect the CitraCharge System
Connect the new water supply line to the CitraChargePro Sys-
tem inlet on one end and to the hot-water supply valve (where
the
dishwasher supply line was disconnected) on the other end.
NOTE: The “in” and “out” ports are marked on the top of the
cartridge head.
Now connect the water line from the dishwasher to the Citra-
Charge System’s ”out” port.
STEP 4
Disconnect the Water Supply
Shut o the hot-water supply to the dishwasher. Some homes
have a separate shut-o valve just for the dishwasher line.
Some will have a single shut-o valve which shuts o all the hot
water under the sink —to the sink faucet and the dishwasher.
Now use an adjustable wrench to disconnect the dishwasher
hot water supply line that connects to the faucet supply valve.
6 7
FIG. 2
FIG. 3
Water Supply Line
to System Inlet
Typical Dishwasher
Water Supply Line
& Shut-o Valve
citrachargepro.com
877-688-6426
Changing the CitraChargePro Spot-Free
Dishwashing System Cartridge
1 Before replacing your cartridge, we recommend having a
towel underneath your CitraChargePro Dishwasher System
to catch any water that may spill. The Dish washer System
is a quick-connect system but does not have a built-in by-
pass. The system may allow some of the pressurized water
to escape when the cartridge is removed.
2 Locate and turn-o the valve for the hot water feed line to the
CitraChargePro Dishwasher System.
Slowly turn on the valve for the hot water feed line to resume
water ow. Check for leaks. If a leak exists, turn o the water
and tighten
the water lines. Conrm that the cartridge is correctly installed.
If leakpersists, return the valve to the “O” position and call
customer support (877-688-6426) for additional troubleshoot-
ing steps.
8 9
FIG. 4
Connected
CitraChargePro
Spot-Free
Dishwashing
System
FIG. 5
citrachargepro.com
877-688-6426
Please Note: For maximum efficiency, please do not
use the CitraCharge Pro Dishwashing System immediately.
Allow the new cartridge to remain in the housing with
minimal water ow for one hour.
Caution: The CitraChargePro Spot-free Dishwasher
System becomes an integrated component of your
dishwasher’s plumbing system and as such periodic
maintenance is required. Never expose the system to
water with a temperature greater than 120 degrees or
pressure above 100 PSI. Replace the cartridge if the
system remains unused for longer than 60 days.
A cartridge should never be left connected to the system
for longer than 6 months before replacement. Always
disconnect or turn off the water supply line if the system
is expected to be idle for longer than six months.
3 Firmly grasp the cartridge and lift up on the red cartridge lock
mechanism situated near the “out” port and turn the cartridge
clock-wise ¼ turn and pull down to disconnect and remove
the cartridge base from the top hood.
4 Remove and discard the spent cartridge.
5 Line up the replacement cartridge into the housing hood and
with rm, upward pressure twist the new replacement cartridge
¼ turn into place.
6 Inspect the cartridge and ensure that it is properly seated
and in good condition. Make certain that the red locking
mechanism is engaged and is holding the cartridge securely
in position.
7 Slowly turn on the valve for the hot water feed line to resume
water ow. Check for leaks. If a leak exists, turn o the water,
check all connections, and re-seat the cartridge. Conrm that
the cartridge is correctly installed. If leak persists, return the
valve to the “O” position and call customer support
877-688-6426) for additional troubleshooting steps.
10 11
citrachargepro.com
877-688-6426
Two-Year Limited Warranty
The CitraCharge Pro Dishwashing System is so dependable
that with each cartridge replacement you can count on enjoying
clean, spot-free dishes every time you run your dishwasher. In
the unlikely event that you have trouble with your CitraCharge
Pro Dishwashing System during the rst two years of owner-
ship, NuvoH2O will, at its option, repair, modify, or exchange it
at no cost to you. To qualify for the Two-Year Limited Warranty,
you must purchase the product from an authorized NuvoH2O
reseller and use only genuine replacement cartridges and parts
from NuvoH2O.
For complete details on our 100% Satisfaction Guarantee
and our Limited Two-Year Warranty please see our website
www.citrachargepro.com.
Registration
To register your CitraChargePro Dishwashing System,
please go to:
www.citrachargepro.com.
If you do not have access to a computer
please call one of our helpful customer service agents at:
877-688-6426.
Money-Back Guarantee
We’re so condent in the performance of the CitraChargePro
Dishwashing System, that if you are not completely satised
within the rst 30 days from the date you bought it, you may
return it for a full refund of your purchase price (less shipping,
handling and installation if applicable).
12 13
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

NuvoH2O CitraPro RC2 Operating instructions

Brand
NuvoH2O
Model
CitraPro RC2
Category
Sanitary ware
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents