EN12
FAVOURITES
This oven allows the settings chosen for cooking your favourite dish to be saved.
At the end of cooking, the display intermittently shows the message “Press << to save”.
To save the settings used for that specific cooking (function, time, temperature, etc.), press the button <<.
The display will show the message “Press OK to save”.
Press the button , and the first available position from 1 to 10 will be proposed. To customise the
position, the number can be changed by turning the Browse knob (- or +) before confirming with the
button . The function is overwritten when the memory is full or the position is already occupied.
If you do not wish to save, just press the button again, go to another function by turning the respective
knob or switch off the oven.
To subsequently call up the saved settings, turn the Functions knob to the symbol and select one of
the stored functions, turning the Browse knob to display the required function.
Press the button and then start cooking.
SETTINGS
1. To modify some display parameters, select “SETTINGS” from the main menu by turning the
“Functions” knob.
2. Confirm by pressing the button : the display shows the parameters that can be modified
(language, acoustic signal volume, display brightness, time of day, energy saving).
3. Select the setting to be changed by turning the “Browse” knob.
4. Press the button to confirm.
5. Follow the instructions on the display to modify the parameter.
6. Press the button ; a message confirming the operation appears on the display.
N.B.:When the oven is switched off, if the ECOMODE (Energy saving) function is selected (ON), the display
switches off after a few seconds, showing the clock. To view information on the display and switch the light
on again, just press any keys or turn one of the knobs. During a cooking function if the ECOMODE is
activated the cavity lamp will be switched off after 1 minute of cooking and reactivated for each user
interaction. If, on the other hand, the function is not selected (OFF), after a few minutes the display is merely
dimmed.
PURECLEAN™ CLEANING CYCLE
To keep the oven in best condition, carry out the PURECLEAN™ cleaning cycle after each use. The cycle
takes 35 minutes, including a cooling stage, and must be carried out as follows:
For the description of this function, see the section CLEANING and the functions table on page38.
1. Proceed with oven cold.
2. Wet the cellulose cloth provided under running water and wring it out so that it does not drip.
3. Open the oven door and remove the enamelled accessories.
4. Cover the bottom of the oven completely with the cellulose cloth.
5. Distribute 350 ml of water evenly on the cellulose cloth. A smaller or greater amount of water could
compromise proper functioning of the cycle.
6. Close the oven door.
IMPORTANT:To prevent steam coming out, do not open the door during the cycle.
7. Select the symbol with the Functions knob: the word PURECLEAN™ appears on the display.
8. Press the button to confirm the choice and start the cleaning cycle. To prevent steam coming
out, do not open the door during the cycle.
9. At the end of the cycle, remove the cellulose cloth and eliminate any residual water in the oven.
10. Then start cleaning using the sponge provided, moistened with hot water (cleaning could be
compromised if delayed by more than 15 minutes).
Press OK to save,
<< to cancel
Favourite
has been saved
Press OK to save, << to cancel
Forced Air2
35 minutes water cleaning
Pureclean
1/1
Insert the cloth
& press
✓
TIME
Cleaning
02:59
TIME
Cleaning
00:00
END TIME
15:00
END TIME
15:00