Classic Accessories 40-012-012001-00 Operating instructions

Hello! I have reviewed the Fitting & Care Instructions for the Golf car enclosure. This document provides detailed steps for installing the enclosure, operating its zippers and doors, and caring for its clear vinyl windows. I'm here to answer any questions you might have about using or maintaining this product.
How do I install the golf car enclosure?

How do I keep the side doors open?

How do I load and unload my golf clubs?

How do I store the front window?

Fitting & Care Instructions

Installation

1. Drape your golf car enclosure over the roof of your golf car with zippered panel at the back.

2. Pull the cover from front to back onto the roof. Make sure the front of the roof enters the

cover pocket first.

3. Attach the 8 elastic hooded straps along both sides of the car (4 on each side).

4. Zip the rear panel down over the back of the car. See figure 1.

5. The side doors open with zippers. To keep the doors open roll them to the back and fasten

them with the provided straps. See figure 2.

6. There is a zippered opening in the back so you can easily load and unload your golf clubs. See

figure 3.

7. The front window rolls down and into the front hideaway pocket for storage. See figure 4.

Tip: If the clear vinyl windows on your cover

are wrinkled from storage you can smooth

them out with a hair dryer. Be sure to set the

dryer on low and hold it at an appropriate

distance.

Tip: Clean clear vinyl windows with mild soap

using your hands to avoid scratching the

surface.

Warranty

This product is factory warranted for workmanship and materials for 3 years from the date of

purchase.

40-12-012001-00 (page 2 of 2) 06.17.10