2. Thorpe Mill
  3. M15733

Thorpe Mill M15733 Operating instructions

  • Hello! I've reviewed the product details for the Thorpe Mill Cotside Bumpers, including models CSB, CSBH, and TRCSB. I understand the fitting instructions vary between the standard models and the TRCSB, and that all models can be wiped clean. I'm ready to answer any questions you have about these products.
  • How do I clean the cotside bumpers?
    How is the CSB and CSBH bumper attached?
    How is the TRCSB bumper attached?
Unit 1a Aireside Business Park
Royd Ings Ave
Keighley BD21 4BZ
Tel: 01535 682 630 Fax: 01535 682 639
[email protected]
Cotside Bumper Information
Codes:- CSB, CSBH, TRCSB,
CSB CSBH TRCSB
136 x 76 cm 136 x 96 cm 200 long
Fitting Instructions for Standard Cotside Bumper CSB & CSBH
• Remove padding from outer bag.
• Taking one half of the pair and open flat.
• Lay padding over top rail and fasten under the bottom rail with Velcro fastenings.
Fitting Instructions for Cotside Bumper TRCSB
• Remove padding from outer bag.
• Taking one half of the pair, open flat.
• With the padding fully opened present padding to the top wooden rail from the inside
of the bed. Wrap padding over top rail and Velcro to where the padding meets the net
(underneath the bottom of top rail). For the second rail, wrap the padding round the
underside of the second rail and Velcro to the top of the second rail.
• Repeat all steps for the other half of padding.
Please note when finished the closed Velcro’s should be on the outside of the bed i.e. so the
patient cannot easily release the padding.
Cleaning Instructions
These types of cotside bumpers can be wipe down with a mild detergent.
Reg No 1502793 VAT 325 5212 86
/