Please read and follow all safety statements, warnings, assembly instructions, use and care directions before
attempting to assemble.
1. When installing and assembling your gazebo, it is recommended that 2 or more adults are involved.
2. Do not use the unit during an electrical storm, as there is a remote chance of getting struck by lightning.
3. Do not climb on top of the gazebo. Falling off the gazebo can result in serious injury, possibly even death.
4. Do not leave the gazebo assembled when there is a risk of high wind, as damage may occur to the
structure.
5. This package contains small items and plastic bags that should be kept away from children.
6. E
nsure that all connectors & poles are firmly secured in position fully. It is important to do so before use so
as to avoid collapsing or damage to the item, which could result in injury.
7. WARNING: Keep flame and heat sources away from the gazebo fabric. The fabric may burn if it is exposed
to prolonged contact with a source of heat. The application of any foreign substance to the gazebo fabric may
render the flame-resistant properties ineffective.
8. WARNING: Please take down the gazebo during strong wind. The manufacturer or retailer is not liable for
any loss of the product or other items due to the failure to take down the gazebo during strong wind.
Tools required: Ladder and Screwdriver (not included) .
Parts List
Pole （1）
A1 2
Pole（2）
A2 2
Base B 4
Base cover C 4
Corner top beam D 4
Small Top Connector E 1
Big Top Connector F 1
Small Top Pole G 4
Long Screen I 2
Short Screen J 2
Shelf K 2
Support bar L 4
Big Canopy O 1
Small Canopy P
1
Hook H 1
AA
M6X15 Bolt
8 PCS
BB
M6 Flat Washer
40 PCS
CC
M6X20 Bolt
16 PCS
DD
M6X35 Bolt
8PCS
M6 Nut
EE
8 PCS
Z M6 Wrench 1 PCS
Hardware Pack 1
Fig.1: Attach Base Cover (C) to Pole A1（A2）,tighten Base (B) with PoOHA1（A2）by using Bolt ( AA ) and Flat
Washer(BB).
Fig.2: Attach the Long Screen (I) and Short Screen (J) to PoOH A1（A2）with Bolt (CC) and Flat Washer(BB)
Fig.3: Insert Corner top beam (D) into Big Top Connector (F), then attach Hook (H) into Big Top Connector (F).
Fig.4: Fix Corner top beam (D) to PoOH A1（A2）with Bolt( DD) and Flat Washer(BB).
Fig.5: Insert Small Top Pole (G) into Small Top Connector (E).
Fig.6: Put Big Canopy (O) onto the Big Top, do not fully spread, attach Small Top Pole (G) to Corner top
beam (D) by M6 X 35 Bolt (DD), M6 flat Washer (BB) and M6 Nut (EE).
AA
M6X15 Bolt
8 PCS
BB
M6 Flat Washer
8 PCS
FF
5X160MM 7” stake
8 PCS
Hardware Pack 2
Fig.7: Put Small Canopy (p), fully spread
Big Canopy (O), using the Velcro’s to fasten
it to the frame; fix Support Bar (L) to Shelf (K)
by using Bolt (AA) and Flat Washer (BB).
Important: For technical assistance on assembly or replacement parts. Please call Sunjoy Industries at
1-866-578-6569 from 8:00 am EST to 8:00 pm PST or fax the replacement part form which is in the box to
1-740-283-3549 or Email [email protected] for assistance.
2016-01
/
