Fig.7: Insert the long center beam
(I) and short center beam (J) into
the big top connector (L).
Fig.9: Insert the small
top pole (M) into the
(N).
Fig.6: Insert the down tube (F) into the big
screen (A), as shown in the picture , G
corresponding C,H corresponding B.
Fig.8: Attach the long center
beam (I) and the bottom of
the short center beam to the
beam (D) with bolt (CC) 、
washer (BB) and nut (DD).
Fig.10: Put the small
canopy (Q) onto the
assembled small top,
secure the four corners,
attach the poppyhead
(P) onto the small top
connector.
Fig.11: Put the big
canopy (R) on the
big top,
do not
unfold, then insert
the assembled
top tube (K).