Fresh Air Screens 1231-168 User manual

1. Measure the exact width of the garage door opening # 1 AND # 2 (from door jamb to door jamb, not from the weather

strips). These measurements should both be the same size, but may not be. Make no allowances.

2. Measure the exact height of the garage door opening # 3 AND # 4 (from the door header (not the weather strip) to the

floor). These measurements should both be the same size, but may not be. Make no allowances.

3. Give us the WIDTH (1st) x HEIGHT (2nd) for your measurement. For example, 16’ (width) x 7’ (height) (Make sure you do

not mix these sizes up because the screen will not fit!) NOTE

: The screen will have zippers as indicated by the blue lines.

DOOR

JAMB

HEADER

1. and 2. Measure the width and height as shown on this chart.

3. Measure the exact height where the angle begins (#3 on the left and #4 on the right). These measurements should both be

the same size, but may not be.

4. Measure the exact length of the angles (#5 on the left and #6 on the right). These measurements should both be the same

size, but may not be.

5. Measure the exact width between the angles at the top of the header. (#7) NOTE: The screen will have zippers as

indicated by the blue lines

and will roll up in between the angles.

HEADER

Outside garage looking into garage

DOOR

JAMB

DOOR

JAMB

Outside garage looking into garage

with 45° angled corners

DOOR

JAMB

Measure as below for garage door openings with 45° angles

How To Measure

This manual is also suitable for

Download PDF