ekwb EK-Loop D-RGB LED Edge Diffused Strip Installation guide

Category
Strip lights
Type
Installation guide
USER GUIDE
EK-Loop
D-RGB LED Diffused Strip (500mm)
Before you start using this product, please follow these basic guidelines:
Carefully read the manual before beginning with the
installation process.
Product should not be used with 12V headers as that will
damage the diodes, they should be powered exclusively by
5V header.
- 3 -
TABLE OF CONTENTS
TECHNICAL SPECIFICATIONS 4
INSTALLING THE D-RGB LED STRIP 4
CONNECTING THE D-RGB LED STRIP 5
SUPPORT AND SERVICE 6
SOCIAL MEDIA 6
- 4 -
- Connection type: 3-pin (+5V, D, Blocked, Ground)
- Rated voltage: 5V DC
- Number of LEDs: 50 (100 LED/m density)
- Strip length: 500 mm
- Strip width: 12 mm
- Cable length: 500 mm
- Strip thickness: 5.65 mm
500 mm
500 mm
TECHNICAL SPECIFICATIONS
INSTALLING THE D-RGB LED STRIP
The EK-Loop D-RGB LED Diffused Strip allows you to upgrade
your PC With 50 individually addressable LED-s that emit
diffused light.
Before installing the D-RGB LED strip, you must
remove the protective foil from the backside of the
LED strip.
DOUBLE SIDED TAPE
PROTECTIVE FOIL
- 5 -
CONNECTING THE D-RGB LED STRIP
Plug the 3-pin connector of the D-RGB LED strip to the D-RGB
HEADER on the motherboard. The LED will work if the pin layout on
the header is as follows: +5V, Digital, Empty, Ground.
STEP 1
D-RGB HEADER
RGB HEADER
In case you need assistance or wish to order spare parts or a new
mounting mechanism, please contact:
https://www.ekwb.com/customer-support/
EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
ekwaterblocks
EKWBofficial
SUPPORT AND SERVICE
SOCIAL MEDIA
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

ekwb EK-Loop D-RGB LED Edge Diffused Strip Installation guide

Category
Strip lights
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI