2. WARRIOR
  3. Sequential

WARRIOR Sequential Operating instructions

  • This document provides detailed fitting instructions for WARRIOR Sequential Front LED Indicators. It covers mounting, wiring, and the use of resistors for flash rate control. I've reviewed the document and am ready to answer any specific questions you have about the installation process or the product.
  • What should I do before installing the LED indicators?
    What if I'm unsure about the fitting process?
    What is the purpose of the included resistors?
    What if I have a LED indicator flasher relay?
    Can the resistors get hot?
SEQUENTIAL FRONT LED INDICATORS
FITTING INSTRUCTIONS
Indicator
RESISTOR
Indicator mounting /
Motorcycle fairing
Motorcycle
Wiring
Resistor to control
flash rate (if needed)
Nut
Thread
Indicator
Running
Light
Ground
FITTING INSTRUCTIONS AND DIAGRAM FOR
WARRIOR SEQUENTIAL FRONT LED INDICATORS
CAUTION
Before fitting your LED indicators, please take the time to read through the fitting instructions and
to study the diagram to ensure you understand how to mount and wire the indicators.
If you are unsure in any way, please contact your local garage or dealer for help.
FITTING INSTRUCTIONS
1. Remove original indicators or drill holes if mounting in different place to OE indicators
2. Unscrew the nut from the rear of the indicator and pass over wires
3. Insert the LED indicators through the indicator mounting hole (Indicator spacers may be
needed on some bikes).
4. Thread nut back over the indicator wires
5. Whilst holding the indicator in its desired position, re-tighten the nut (do not over tighten)
6. Wire the indicators as per the wiring diagram below.
The resistors supplied with the indicators are ideal most vehicles fitted with 21W indicator bulbs
(although some models may require an extra resistor to give the proper flash rate). If you prefer
to fit (or your bike is already fitted with) an LED indicator flasher relay, then the supplied
resistors will not be required.
If used for extended periods (e.g. hazard lights), the resistors can get hot, so it is preferable to
mount the resistors against a heat resistant surface, away from OE wiring looms.
Indicator adaptor leads are available separately for most motorcycles, should you not wish to
modify the wiring on your motorcycle.
/