Home » GEPRC » GEPRC GEP-M8Q Multi Functional GPS Positioning Module User Manual

GEPRC GEP-M8Q Multi Functional GPS Positioning Module

GEPRC GEP-M8Q Multi Functional GPS Positioning Module

User Manual

Manuals+ — User Manuals Simplified.

Contents

1 Product Description

7 Include

8 Contact

9 Documents / Resources

10 Related Posts

Product Description

The GEP-MBQ multi-functional GPS positioning module features small size, fast positioning, stable connection

and ease of use; the right circularly polarized patch antenna provides excellent reception. Built-in QMC5883L

high-precision magnetometer provides accurate orientation pointing; integrated MS5611 high-precision

barometer, subtle altitude changes are not to be missed for more stable flight. Ideal for use on model products

such as FPV drone, multi-rotors and fixed wing .

Barometer:MS5611

Baud Rate: 115200bps

Output Connector: SH1.0-6P

Output Frequency: 10Hz

MA Alignment: CW180″flip

Speed Accuracy: 0.05 m / s

Communication Protocol: UBLOX(GPS), 12C(Mag&Baro)

Horizontal positioning accuracy: horizontal <2.SM, SBAS < 2.0M

Timing Accuracy: 30 ns

Receiving Sensitivity: Trace-162dBrn, Capture-160dBm

Installation

The GEP-M8Q GPS module has an integrated magnetometer and barometer, the following should be

noted when installing it.

1. The GPS antenna must be oriented towards the sky, do not block the antenna.

2. The magnetometer must be kept away from magnetic interference in order to work properly, so when installing

the M8Q module, be careful not to install it close to places where magnetic interference can be easily

generated, such as power lines.

3. Do not block the opening of the barometer, otherwise it will not be possible to read the atmospheric pressure

data.

4. The supplied sponge can be used to cover the top of the barometer to reduce the disturbance of airflow and

3. Restart the flight control after setting up, the flight control will light up the GPS logo after setting to GPS.

Magnetometer & Barometer Settings

1. Set the magnetometer and barometer to QMC5883 and MS5611 respectively in the configuration screen.

2. If the GPS module is mounted in the same direction as the arrow indicates, set the magnetometer orientation

to CW 180° flip

3. The flight control will light up when the magnetometer and barometer are set.

4. calibration of the magnetometer according to ground station instructions to ensure that the magnetometer is

pointing correctly.

5. Check that the barometer data is levelling off in the sensor interface when at rest

Include

Website: http://geprc.com

Facebook

facebook.com/geprc

Official website

www.geprc.com

Instagram

instagram.com/geprc

YouTube

Manual