Minka Group 1738-167 User manual

Minka Group
Brand
Minka Group
Model
1738-167
Type
User manual

This manual is also suitable for

8
ASSEMBLING THE FIXTURE (Fig. 1)
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture and all mounting hardware
from junction box.
2. Carefully unpack your new fixture and lay out all the parts in a
clear area. Take care not to lose any parts necessary for
installation.
3. Thread the stem (I) into the coupling (K), then secure with the
hex nut.
4. Place the tube (J), wheel (H), canopy (D), steel washer (G),
and lock washer (F) over the stem (I) and secure with hex nut
(E).
5. Place the glass shade (M) over the socket (N) and secure it
with the socket ring (L) (SKT-RING-26).
6. Attach the mounting plate (B) to the outlet box using the outlet
box screws (A) (Size: 8-32 * 1 L.). The side of the mounting
bar marked “GND” must face out.
CONNECTING THE WIRES (Fig.2)
7. At this point, connect the electrical wires as shown in figure 2,
making sure that all wire connectors are secured. If your
outlet box has a ground wire (green or bare copper), connect
the ground wires from the mounting plate to it. Otherwise,
connect the fixture’s ground wire directly to the mounting plate
using the green screw provided. After the wires are
connected, tuck them carefully into the outlet box.
COMPLETING THE INSTALLATION (Fig.1)
8. Attach the fixture body onto the mounting plate (B) by
securing the ceiling canopy (D) onto the mounting plate (B)
with the mounting screw (C).
9. Install the bulb(s) in accordance with the fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
Your installation is now complete. Return the power to the junction
box and test the fixture.
Fig.1
GLASS SHADE(M)
SOCKET(N)
SOCKET RING SKT-RING-26 (L)
STEM WITH HEX NUT(I)
TUBE(J)
COUPLING(K)
WHEEL(H)
CANOPY(D)
STEEL WASHER(G)
LOCK WASHER(F)
HEX NUT(E)
MOUNTING SCREW(C)
Set #A-020-143
-Circular Strap
-Ground Screw
-Mounting screws(2)
INSTALLATION INSTRUCTION FOR FIXTURE#1738
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
  • Page 1 1

Minka Group 1738-167 User manual

Minka Group
Brand
Minka Group
Model
1738-167
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents