2. Real Fyre
  3. 17

Real Fyre 17, 17 Valve Heat Shield Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Real Fyre 17 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
REV 0 - 1807191335
L-A2-360
1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
17 VALVE HEAT SHIELD
REPLACEMENT INSTRUCTIONS
This heat shield is for replacement on 17 valve models.
To install, follow the steps below:
1. Remove the old/existing valve heat shield (from the
valve).
Note: DO NOT remove the existing regulator heat shield
(if equipped).
2. Cover the valve with the heat shield as shown in
Fig.1-1 and Fig.1-2.
Refer to the owner's manual supplied with your burner/
valve system for all other product details.
Fig. 1-1
Fig. 1-2
Ensure existing
regulator heat
shield remains
properly placed
Model# HS-35
(valve not included)
Place new valve
heat shield
(shown on G45 burner)
HEAT SHIELD
MUST BE
PROPERLY
PLACED
TO PREVENT VALVE DAMAGE AND FAILURE:
IT IS CRITICAL THAT THE HEAT SHIELD BE
PLACED CORRECTLY OVER THE VALVE PRIOR TO
OPERATION.
KEEP LAVA GRANULES/COALS, SAND/
VERMICULITE, EMBERS/GLASS, AND ALL FOREIGN
OBJECTS AWAY FROM THE PILOT ASSEMBLY,
VALVE ASSEMBLY, AND HEAT SHIELD DURING
MEDIA PLACEMENT AND AT ALL TIMES.
/