Knoll IR31 Installation guide

Brand: Knoll

Model: IR31

Type: Installation guide

IR31

MINI INFRARED

EMITTER

Information and

Installation Guide

To block remote control signals from other

emitters or local remote controls cut black

window mask to the component window size

and also cover IR31 cover plate.

Black Window Mask

IR31

IR31 Enlarged Side View

Clear adhesive layer.

Stick this side to

component window.

Replace adhesive or

add clear silicon

sealer if necessary.

High output side.

Used when IR31

is not stuck on

component IR

window. Maximum

range is about 1m

or 3 feet.

Wire

Low output side.

IR31 Plug and Wire Polarity

+ - +

-

Wire

Tip

v2.1

Typical Installation

To IR55

connection

block

Receiver

Infared emitter IR31

low output (flat) side

attached directly to

IR sensor window.

Cabinet Installation

Receiver

Note: In this mode, other IR

signals can pass through IR31

and control component. To stop

this cover the IR31 and component

sensor window with black tape.

Shelf

Shelf

Note: In this mode, the emitter is

placed at the front of the shelf either

above or below the IR window. It is

less reliable than direct attachment

but looks better.

Cabinet Installation

Receiver

side view

Shelf

Shelf

Note: In this mode, the emitter

is attached to the door of the

equipment rack with the high

output side facing the component

IR window. Obviously the emitter

will be less reliable when the rack

door is open .

Equipment

Rack Door

IR31

IR31

Caution: Emitters can easily be

destroyed by connecting them

directly to power supplies or batterys.

Knoll Systems tel. (604) 272 4555

Point Roberts WA and Richmond BC

1

Knoll IR31 Installation guide

Brand: Knoll

Model: IR31

Type: Installation guide

Download PDF

Related papers

Other documents