GKE 1870 A++

Bauknecht GKE 1870 A++ Program Chart

  • Hello! I am an AI chatbot trained to assist you with the Bauknecht GKE 1870 A++ Program Chart. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How do I adjust the freezer's internal temperature?
    What is the default temperature of the freezer?
    How do I activate the Eco mode?
    What happens when I activate the Eco mode?
    How do I deactivate the Eco mode?
    What is the 'door open alarm' and how do I stop it?
    What is the 'temperature alarm' and how do I stop it?
    What is the 'long black-out alarm' and how do I stop it?
    What does the 'FF' error message on the display mean?
    How do I defrost the freezer?
1. Control panel
2. Ice packs (inside - if provided for)
3. Rating plate (at side of drawer)
4. Freezing compartment
5. Zone for drawers and pull-out
baskets
Storage zone
Freezing zone
Note: The design of drawers and
accessories may vary, depending on
the model.
4
1
5
3
2
D GB I FINDKNPENLF SGR
A. Green Intelligence. "Green Intelligence"
activation indicator (See enclosed instructions)
B. On/Standby. Standby button. Press for at least
3 seconds to activate it. Press the icon once to
reactivate the keypad.
C. Temperature. Set temperature indicator.
D. Temperature. Temperature setting button.
E. Key Lock. Key Lock activated indicator. Press
for at least 3 seconds to activate/deactivate the
Key Lock. When activated, pressing the other
icons activates an audible signal.
F. Stop alarm. Press in case of alarm.
G. Black-out alarm. Long Black-out Alarm
indicator. (See the section "alarm signalling").
H. Fast Freeze Fast Freeze on indicator. Press to
activate/deactivate the Fast Freeze function. The
Fast Freeze function switches off automatically
after 48 hours.
CONTROL PANEL
ABCD
EFGH
PRODUCT SHEET
GB
FINDKNSGRIPENLFGBD
Freezer inside temperature adjustment
The appliance is normally factory-set for operation at the recommended temperature of -18°C.
The inside temperature setting can be adjusted between -16°C and -24°C, proceeding as follows:
Press the inside temperature adjustment button D. The storage temperature can be changed by -1°C with
each press of the button: the value flashes cyclically between -16°C and -24°C.
The "Green Intelligence" function is activated automatically in case of opening of doors and the introduction
of small amounts of food to be frozen. Its duration is variable and depends on the product load conditions
and the outside temperature. It does not require any intervention by the user and switches off automatically
when normal operating conditions are restored
This optional function can be used to save energy.
To activate the Eco mode, press the buttons E and H together for 3 seconds until an audible signal sounds.
Two seconds after activation of the Eco mode, the display goes off, except the Green Intelligence icon (and
the audible signal is deactivated, if on).
To adjust the temperature or use other functions, it is necessary to activate the display by pressing any
button.
After about 15 seconds without performing any action, the display goes off again and only the Green
Intelligence icon remains visible.
To deactivate this function, press the buttons E and H together for 3 seconds until an audible signal
sounds. The normal display is restored.
The Eco mode is automatically disabled after a power failure or a fault alarm.
Remember that this function does not disconnect the appliance from the power supply
ECO MODE
FINDKNSGRIPENLFGBD
Note: The temperature alarm may even be activated following prolonged opening of the door or after
fresh food products have been placed in the freezing zone; the temporary increase in temperature
signalled does not affect the perfect preservation of already frozen food.
ALARM SIGNALLING
Signal Cause Cure
Door open alarm The audible alarm is
activated.
The door has remained
open for more than 2
minutes
Close the door
Temperature
alarm
The audible alarm is
activated, the set
temperature flashes and
the red light F remains on
The inside temperature is
not adequate
Press the button F; the
audible alarm stops, the
set temperature flashes
and the red light F
remains on until a
temperature < -10°C is
reached.
Long black-out
alarm
The audible alarm is
activated, the light G
remains on, the light F
flashes and the displays
shows the maximum
temperature reached.
Prolonged power
failure, able to cause the
inside temperature to
increase to 0°C
Press the button F; the
audible alarm stops, the
set temperature flashes
and the red light F
remains on until a
temperature < -10°C is
reached.
Malfunction The message "FF" flashes
on the display C
Product malfunction Contact the After-Sales
Service
1. Put the product in standby mode by pressing the button B for at
least 3 seconds.
2. Unplug the appliance or turn off the main switch.
3. Insert the chute (contained in the accessories bag) in the special
slot (see figure).
4. Follow the instructions given in the instruction booklet.
5. Reinsert the plug or turn on the main switch.
6. Reactivate the product by pressing the button B once.
5019 403 01002 Printed in Italy 03/12 - Bauknecht
®
Registered trademark/TM Trademark of Whirlpool group of companies - © Copyright Whirlpool Europe s.r.l. 2012. All rights reserved - http://www.bauknecht.eu
DEFROST
/