FSH FES15 Technical Manual

Type
Technical Manual

This manual is also suitable for

FSH FES15 is an electric strike designed for use with timber door frames. It features a 1mm clearance between the door latch and the front face of the strike keeper to prevent the door from exerting pressure on the keeper when the door is closed. The strike is easy to install, with mounting steps outlined in the instruction manual. It has a 12VDC or 24VDC power input with a current of 200mA or 100mA respectively. The strike has a blue wire for normally open, a black wire for common, and an orange wire for normally close. It also has a DSS (Door Status Sensor) contact rating of max.

FSH FES15 is an electric strike designed for use with timber door frames. It features a 1mm clearance between the door latch and the front face of the strike keeper to prevent the door from exerting pressure on the keeper when the door is closed. The strike is easy to install, with mounting steps outlined in the instruction manual. It has a 12VDC or 24VDC power input with a current of 200mA or 100mA respectively. The strike has a blue wire for normally open, a black wire for common, and an orange wire for normally close. It also has a DSS (Door Status Sensor) contact rating of max.

FES15M/ FES15 ELECTRIC STRIKE
DOOR LATCH POSITION
As shown in Fig.1, there should be a 1mm gap between the door latch and the front face of strike keeper
to prevent the door from exerting pressure on the keeper when door is closed.
MOUNTING STEPS OF STRIKE
1). Position the strikes against the frame, mark and drill the hole sizes as shown on Figure 2 and 3.
2). Drill cable exit hole on door frame.
3). Make sure electrical connections are followed correctly.
4). When the door is closed, ensure that there is no pressure on the front face of strike keeper.
Door latch
Front face of
strike keeper
Keeper
Door Frame
Figure 1
Door
1mm clearance
Keeper
INSTALL ON TIMBER DOOR FRAME
35
31
3
6
.
9
93.5
3
2
9
4
.
5
9
5 csk screw
Figure 3
Figure 2
3
3
12
35
Power Input
12 VDC – current 200 mA 24 VDC – current 100 mA
Note: Select from prewired assembly to use plugs.
There is no polarity on power input.
Wire output
DSS ( Door Status Sensor) Black (Common)
Blue (Normally Open) Orange (Normally Close)
DSS contact rating
Max. current 100mA
Max. voltage 30VDC
12 Volt plug:
24 Volt plug:
RED
BLUE
YELLOW
BLACK
RED
BLUE
YELLOW
BLACK
12 VDC/ 200 mA
24 VDC/ 100 mA
Figure 3
5 countersunk
CONVERSION:
POWER TO LOCK <=> POWER TO OPEN
1
2
3
4
5
6
1
2
3
4
5
6
Figure 4A
Figure 4B
Procedures to convert Power to Open (Figure 4B) to Power to Lock (Figure 4A):
Step 1: Remove the security plug cover(2) with the provided security screw(1).
Step 2: Remove the spring screw(3) from the opening hole.
Step 3: Remove the Barbell (4) and replace in reverse position with long part in and short part out.
Step 4: Replace the spring screw(3) .
Step 5: Refit the security plug cover(2) .
Procedures to convert Power to Lock (Figure 4A) to Power to Open (Figure 4B):
Step 1: Remove the security plug cover(2) with the provided security screw(1).
Step 2: Remove the spring screw(3) from the opening hole.
Step 3: Remove the Barbell (4) and replace in reverse position with short part in and long part out.
Step 4: Replace the spring screw(3) .
Step 5: Refit the security plug cover(2) .
WARNING: Do not attempt to swivel the keeper while changing function. The spring screw must
be in place before operating the strike.
V 1.2 2009
  • Page 1 1
  • Page 2 2

FSH FES15 Technical Manual

Type
Technical Manual
This manual is also suitable for

FSH FES15 is an electric strike designed for use with timber door frames. It features a 1mm clearance between the door latch and the front face of the strike keeper to prevent the door from exerting pressure on the keeper when the door is closed. The strike is easy to install, with mounting steps outlined in the instruction manual. It has a 12VDC or 24VDC power input with a current of 200mA or 100mA respectively. The strike has a blue wire for normally open, a black wire for common, and an orange wire for normally close. It also has a DSS (Door Status Sensor) contact rating of max.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI