ENABLING BRIGHT OUTCOMES
Installation manual
F40 Dust Filter
Registered office: Barco NV
President Kennedypark 35, 8500 Kortrijk, Belgium
www.barco.com/en/support
www.barco.com
Barco Fredrikstad AS
Habornveien 53, N-1630 Gamle Fredrikstad, Norway
www.barco.com
1 Filter installation................................................................................................................................................................................................5
1.1 Kit Content ...............................................................................................................................................................................................6
1.2 Environmental Conditions...............................................................................................................................................................6
1.3 Assembly and installation................................................................................................................................................................6
1.4 Maintenance ...........................................................................................................................................................................................7
1.4.1 Cleaning the filter ..............................................................................................................................................................7
1.4.2 Replace the filter ...............................................................................................................................................................7
R5911521 /00 F40 Dust Filter
3
Table of contents
R5911521 /00 F40 Dust Filter4
R5911521 /00 F40 Dust Filter6
1.1 Kit Content
Kit Content
Article Number
Description Quantity
R8782928 Dust Filter 1
505–0276 S/D Filter screw Captive 6
1.2 Environmental Conditions
No changes in environmental conditions with filter installed..
1.3 Assembly and installation
Preparing the Filter frame
1. Put the captive screws (505–0276) in to the holes as indicated in the illustration below. Press the screws until
they snap into position.
Image 1-1: Entering the capyive screws
2. Apply the filter frame over the projector’s side cover. Ensure that the captive screws in the filter frame align
with the holes in the projector side cover, as shown in the illustration.
Filter installation
R5911521 /00 F40 Dust Filter 7
Image 1-2: Applying the filter frame Image 1-3: Microswitch versus stud alignment
3. Ensure that the stud on the filter frame engages the micro switch in the front of the side cover.
4. Hold the filter frame in position, and enter the screws in each corner in the corresponding threads in the side
cover. Tighten the screws in a cross pattern. Enter and tighten the two last screws
1.4 Maintenance
1.4.1 Cleaning the filter
The filter can be cleaned in two ways. Either by use of a vacuum cleaner, or by dismounting the filter and use
compressed air.
Both methods must be performed with caution.
1.4.2 Replace the filter
The dismounting of the filter unit is performed in the reverse order as the mounting process.
Filter installation
Barco Fredrikstad AS | Habornveien 53, N-1630 Gamle Fredrikstad, Norway
Registered office: Barco NV | President Kennedypark 35, 8500 Kortrijk, Belgium
www.barco.com
R5911521 /00 | 2019-04-08
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Barco FL40-WU MKII Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Barco Avielo Helios Owner's manual
-
Barco FS40-4K MKII Installation guide
-
Barco CRPN-62B Owner's manual
-
-
Barco Avielo Optix Owner's manual
-
-
-
-
-