Axxent GMX-2500 Operating instructions

Category
Musical Equipment
Type
Operating instructions

Axxent GMX-2500

The Axxent GMX-2500 is a professional audio mixer designed for a wide range of applications, including live sound reinforcement, recording, and playback. With its comprehensive feature set and intuitive controls, the GMX-2500 is an ideal choice for both professional and home users.

The mixer features three XLR microphone inputs with +48V phantom power for condenser microphones, two 1/4" TRS line inputs, and five RCA stereo aux inputs. Each channel has a 3-band EQ and a volume control. The GMX-2500 also has a 7-band graphic EQ for overall tone shaping.

The mixer's outputs include XLR stereo main outputs, two mono zone outputs, and RCA stereo record outputs. The GMX-2500 also has a built-in limiter to protect your speakers from damage.

Axxent GMX-2500

The Axxent GMX-2500 is a professional audio mixer designed for a wide range of applications, including live sound reinforcement, recording, and playback. With its comprehensive feature set and intuitive controls, the GMX-2500 is an ideal choice for both professional and home users.

The mixer features three XLR microphone inputs with +48V phantom power for condenser microphones, two 1/4" TRS line inputs, and five RCA stereo aux inputs. Each channel has a 3-band EQ and a volume control. The GMX-2500 also has a 7-band graphic EQ for overall tone shaping.

The mixer's outputs include XLR stereo main outputs, two mono zone outputs, and RCA stereo record outputs. The GMX-2500 also has a built-in limiter to protect your speakers from damage.

Gastro-Mixer GMX-2500
®
Operation Manual
Josef Becker Pro Audio Technik · Technologiezentrum Herzbachtal · Zum Wartturm 15 · D-63571 Gelnhausen
Fon: +49-6051-9140-0 Fax: +49-9140-59 · mail@proaudio-technik.de · www.proaudio-technik.de
1
2
3
GMX-2500 setup and operation
When opening the box, you should nd:
The mixer GMX-2500
The 19" rack mount brackets (pre-installed)
• Equalizer protective cover plate (pre-installed)
Two adapters: phone/RCA for the front line inputs
• Powercord
Unit dimensions:
435 mm x 280 mm x 88 mm (without rack mount brackets)
Weight:
4.4 kg net, 5.9 kg shipping
After unpacking the mixer please plug in the delivered
power cord into the power input jack of the unit. Before
connecting the mixer to the wall outlet, make sure that the
"POWER" switch on the right of the front side is in "OFF"
position. Also the main volume control (MASTER) should
be set fully counterclockwise ("0" position).
Attention: Due to safety reasons the case never should
be opened by the user. Beside, this also may void any
warranty claims!
Now you may connect the mixer to a wall mains outlet.
Please make sure you rst switch on the GMX-2500 and
then the power amplier. This way you avoid annoying
audible transient noise.
On the left hand side you will nd the 3 pin XLR female con-
nectors (1), the microphone inputs for connecting balanced
microphones. Close by on the right is a recessed push
button (2) for activation of phantom power when using
condenser microphones. When dynamic microphones
are hooked up, the switch remains in the "OFF" position.
Please note, that the microphone inputs on the front and
on the rear side are used in parallel. This means that you
may either use the front- or the rear inputs, not both of the
XLR input pairs simultaneously.
Beneath the XLR inputs you will nd two 1/4" phone jack
inputs (3). These are line level inputs, for example to con-
nect a stereo keyboard or a device for playback music. The
left phone jack is a stereo type (TRS)
e.g. tip = left channel, ring = right
channel input. When using mono
phone plugs connect left and right
plugs as printed on the housing. In
case you want to use a cable with
RCA connectors, we have enclosed
two suitable adapters in the packag-
ing for your convenience.
controls on the front side
Gastro-Mixer GMX-2500
®
Operation Manual
Josef Becker Pro Audio Technik · Technologiezentrum Herzbachtal · Zum Wartturm 15 · D-63571 Gelnhausen
Fon: +49-6051-9140-0 Fax: +49-9140-59 · mail@proaudio-technik.de · www.proaudio-technik.de
Bedienelemente Frontseite (Forts.)
4 5 6 7 8 9
Each of the three front inputs provides a 3 band equalizer
(4), "LOW, MID and HIGH" and a volume level control (5).
Located right from the volume controls is the 5-position
source select switch (6) (SELECT). With this rotary knob you
easily can select any of the 5 RCA stereo inputs on the rear
side of the mixer, labelled AUX1 to AUX5. Typically these
inputs are used to connect CD/MP3 player, cassette player,
tuner or similar devices. Right of the source selector knob
you will nd the volume control (7) for the selected source.
In the middle of the front panel you surely will see the pro-
tection plate, covering the 7 band equalizer. Reason for this
cover plate is to protect the equalizer settings made by an
acoustic engineer after calibrating the complete system.
If you may want to make your own sound adjustments,
and no calibration settings by
an acoustical expert must be
protected against unwanted
changes, feel free to remove
this metal cover plate. The gain
range of the equalizer is limited
to ± 6 dB by intention in order
to avoid extreme setting which
may result in an unwanted
"twisted" frequency response
and also may cause damage to
the system or components.
On the right hand side of the GMX-2500 you will see the
output volume controls, one for the "MASTER" (9), the main
stereo output, and two smaller control knobs (8) for adjust-
ing the level of the two mono zones. For example the
stereo main output may be used in a pub or bistro to drive
the main loudspeakers, a zone output for the washrooms/
hallways and another one for separate smaller room. The
balanced XLR output jacks for the mentioned dierent
PA areas are located on the rear side. Above the "MASTER"
volume control you see a row of three LED indicators (10)
for power on, signal presence and for the limiter activity.
Limiter: Located on the right bottom side of the front
panel you see two recessed con-
trols for the limiter, one is the
on/o switch and the upper is the
screwdriver adjustable setting
for the limiter attenuation level.
The limiter is an important tool
to keep the sound pressure level
(SPL) within a prexed maximum,
for example if government rules
do not allow SPLs above a cer-
tain maximum level. With this
limiter you can rest assured that this maximum level is
not exceeded–and you even can have this maximum level
measured and calibrated by an acoustic engineer and have
it ocially sealed. The output level of the GMX-2500 may
be attenuated up to 30 dB. Last not least above the limiter
section you may have already noticed the "POWER" switch.
No further explanation necessary here...
Gastro-Mixer GMX-2500
®
Operation Manual
Josef Becker Pro Audio Technik · Technologiezentrum Herzbachtal · Zum Wartturm 15 · D-63571 Gelnhausen
Fon: +49-6051-9140-0 Fax: +49-9140-59 · mail@proaudio-technik.de · www.proaudio-technik.de
Connections on the rear panel
1 2 3 4 65
Left hand side on the bottom is the mains fuse holder (2)
and the fuse switch (1). Should the fuse really gets blown,
please replace it with a fuse of the same type (63 mA,
slow blow). Should this happen again do not use another
"stronger" type of fuse or unscrew and open the unit. In
this case please call your dealer or installer for repair.
We already mentioned the ve RCA stereo aux inputs (4)
on the rear panel. Left from these you will notice RCA jacks
labelled "REC" (3). These are, we think you guessed it,
intended for recording purposes (tape-/cassette recorder
etc.).
Above these RCA jacks are the XLR outputs. "RIGHT" and
"LEFT" (5) are the stereo main outputs, the other two the
mono outputs for ZONE 1 and ZONE 2. Right hand on the
bottom are the XLR microphone inputs (6), connected in
parallel wit the corresponding inputs on the front side (only
use either one!)
The GMX-2500 is delivered from factory with ready installed
rack mounts ("ears") for mounting in a standard 19" rack.
These rack mounting brackets are easily detachable for set-
ting up the mixer on a table or any other surface.
Now there is nothing left but wishing you trouble free opera-
tion of the GMX-2500. Enjoy the excellent sound it delivers.
DECLARATION OF CONFORMITY
We declare as our sole responsibility that this product is in compliance with the
EMC Directive 89/336/EEC and conforms to the requirements of the Harmonized
Product Standards EN 55013 (Product Emissions), and EN 55020 (Product Immu-
nity).
Gastro-Mixer GMX-2500
®
Operation Manual
Josef Becker Pro Audio Technik · Technologiezentrum Herzbachtal · Zum Wartturm 15 · D-63571 Gelnhausen
Fon: +49-6051-9140-0 Fax: +49-9140-59 · mail@proaudio-technik.de · www.proaudio-technik.de
1
2
3
MIC1
GND
S1
+48V
1mV 100mV
GND
1
2
3
MIC2
GND
S1
+48V
1mV 100mV
GND
0,775V 100mV
GND
AUX1AUX2AUX3AUX4AUX5
1
2
3
4
5
6
7
5WAY
1
2
3
4
5
6
7
5WAY
7EQ-L
7EQ-R
GND
GND
GND
GND
LIMITER-L
LIMITER-R
Cold
3
Gnd
1
Hot
2
OUT-L
Cold
3
Gnd
1
Hot
2
OUT-R
GND
GND
GND
ON/OFF
ON/OFF
Cold
3
Gnd
1
Hot
2
SEPARATE Z1
GND
0,775V
0,775V 0,775V
1
1
1
GND
ON
AC230V
+48V
+15V
GND
-15V
GND
AC/DC
POWER
SIGNAL LIMIT
GND
Cold
3
Gnd
1
Hot
2
SEPARATE Z2
GND
+/-6dB
+/-6dB
+/-6dB
+/-6dB
+/-6dB
LINER
J7
J6
LINEL
Blockdiagram of the Gastro-Mixer GMX-2500
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Axxent GMX-2500 Operating instructions

Category
Musical Equipment
Type
Operating instructions

Axxent GMX-2500

The Axxent GMX-2500 is a professional audio mixer designed for a wide range of applications, including live sound reinforcement, recording, and playback. With its comprehensive feature set and intuitive controls, the GMX-2500 is an ideal choice for both professional and home users.

The mixer features three XLR microphone inputs with +48V phantom power for condenser microphones, two 1/4" TRS line inputs, and five RCA stereo aux inputs. Each channel has a 3-band EQ and a volume control. The GMX-2500 also has a 7-band graphic EQ for overall tone shaping.

The mixer's outputs include XLR stereo main outputs, two mono zone outputs, and RCA stereo record outputs. The GMX-2500 also has a built-in limiter to protect your speakers from damage.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI