3.25
83
MAX. LOAD 10 lbs 10 lbs
CAPACITY (4.5 kg) (4.5 kg)
WEIGHT .5 lbs .6 lbs
(.23 kg) (.27 kg)
SHIPPING 1 lb 1 lb
WEIGHT (.5 kg) (.5 kg)
MODEL: *CMR 405, CMR 410
Peerless Industries, Inc.
3215 W. North Ave. phone: (708) 865-8870
Melrose Park, IL 60160 fax: (708) 865-2941
ISSUED: 2-27-97 SHEET NO:050-9501-5 01-03-07 page 1 of 1
TECHNICAL DATA SHEET
LIGHT DUTY CAMERA MOUNT
Architects Specifications:
The Camera Mount shall be a Peerless model CMR 405 or CMR 410 and shall be located
where indicated on the plans. It shall be constructed of nylon to eliminate ground loop
problems. It shall feature a ball and socket design for a wide range of tilt and swivel. The
mounting hole pattern shall allow for attachment to a wall or ceiling, or direct attachment to
an electrical outlet box. Assembly and installation shall be done according to instructions
provided by the manufacturer.
All dimensions:
inch
mm
A
housing
SIDE VIEW
B
.28 dia.
.15 dia.
2.125
54
3
76
(mounting plate)
BACK VIEW
Attachment to mounting surface:
Camera Mount may be attached to wall or ceiling via the four large
mounting holes in the mounting plate, or directly to a standard electrical
outlet box via two small mounting holes. Hardware for attaching
Camera Mount to mounting surface is not included.
Camera attachment and position:
Angle of ball stud can be adjusted by loosening tension screw. Ball stud
can be removed for attachment to camera, then reattached and locked
into position at the desired angle by tightening tension screw. Ball stud
removal is not required for camera attachment.
ISOMETRIC VIEW
housing
tension screw
.75 dia. cable/wire
access hole
.75 dia. cable/
wire access hole
ball stud
mounting plate
Patent Pending
© 2007 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
CMR 410 CMR 405MODEL
A 4.125 in 6.5 in
(105 mm) (165 mm)
B 5.0 in 7.375 in
(127 mm) (187 mm)
PEERLESS 5" SECURITY CAMERA MOUNT (CMR 405)
PEERLESS 7" SECURITY CAMERA MOUNT (CMR 410)
This product must be
installed by a qualified,
professional installer.
R
* CMR 405 is not UL listed
4.75
121