6English
HOW TO USE THE UNIVERSAL HOLDER?
• Release the cramps of the Genius main unit by pushing the button between
the cramps.
• Put your telephone between the cramps.
• Close the cramps in a way that they hold the telephone and it therefore
cannot fall.
• Take the telephone out of the holder without releasing the cramps by sliding
the telephone to the top side.
• To insert the telephone, you slide it from the top side between the cramps of
the Genius.
• You only have to adjust the cramps to the size of your telephone once.
CONNECTING THE PHONE TO THE CONNECTOR CABLE
• Activate the power supply to the Genius by starting the engine and connecting
the cigarette plug (if applicable).
• Connect the Genius connector to the mobile phone after the power supply
is activated.
• Charging function is activated now (if applicable).
Important:
During installation always make sure that the power cord is inserted into
the cigarette lighter and power provided before connecting your mobile
phone. The connection of your mobile phone should ALWAYS be the LAST
step of complete mr Handsfree installation.
HOW TO USE THE ANTI-THEFT SYSTEM
The Genius main unit can be released from the holder. When the two buttons
are pressed together, the main unit can be taken of the Genius main unit
holder. This way you can remove all important electronics and avoid being robbed.
IMPORTANT!
• Always read the ‘TROUBLE-SHOOTING’ chapter carefully.
• The mr Handsfree ‘Special Brand’ mobile phone connector can be
obtained by mail or directly from your local supplier.
• Due to the ‘Special Brand’ mobile phone connector which can be ordered
separately for each mobile phone model (Nokia, Ericsson etc.), your mr
Handsfree Genius is suitable for any type of mobile phone.
OPERATION OF MR HANDSFREE GENIUS
HOW TO SWITCH ON YOUR GENIUS WHILE USING THE CIGARETTE
PLUG?
• Insert your mr Handsfree power cord into the cigarette lighter of your car to
switch mr Handsfree in ON-position. Please note that for several brands of
cars the engine has to be turned on before the cigarette plug is activated.
• LED indicator lights on the cigarette plug.
• To switch off, you simply plug out your power cord from the cigarette lighter.
When the Built-in cable is used, and connected to the continuous power, the
Genius is always switched on.
6
M_Genius_GB_2.pmd 21.03.2005, 11:536