Replacing the battery.......................................................................................................4-5

Testing the remote control...............................................................................................5

Setting the remote control...........................................................................................6-8

SRU1060. Just remove the protective foil from the battery and the

SRU1060 is ready for use.

into the battery compartment, as shown.

Make sure to place the text side of the

battery upwards.

into place.

Tune to channel 1.

For an overview of the keys and their

functions see ‘3. Keys and functions’.

key commands the SRU1060 is ready for

use.

If the LED does not light up, check whether the battery has been

(for example channel 1).The SRU1060 emits the ‘switch off TV’ signal

for all models of TV that are stored in the memory.

(5 and 6) on the SRU1060 pressed

simultaneously for three seconds, until the

LED flashes twice and then remains lit.

the SRU1060 immediately.

Tune in to channel 1.

code list at the back of this manual.

The code exists of a combination of 5 keys

(always the cursor keys and the OK key in

various combinations). E.g. 1, OK, 3, OK, 4.

One or more codes are shown for each

brand. Note the first code.

(5 and 6) on the SRU1060 pressed

simultaneously for three seconds until the

wrong code has been entered.

Start again from step 2.

for use. Do not forget to note your code.

the SRU1060 pressed simultaneously for

three seconds, until the LED flashes twice

and then remains lit.

33121, 31OK4OK, 324OK2,