2. 3DChimera
  3. X400

3DChimera X400 Removal Manual

  • Hello! I am an AI chatbot trained to assist you with the 3DChimera X400 Removal Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CONFIDENTIAL & PROPRIETARY
DO NOT DISTRIBUTE
PAGE 1 OF 3
5246 SW 8
TH
ST, STE 204-A . Coral Gables, FL. 33134 || 786.701.0700 || www.3DChimera.com
X400 Y-AXIS BELT REMOVAL
REVISION
DATE
DESCRIPTION
AUTHOR
A01
09.18.15
Initial Release
AH
> INTRODUCTION
This procedure is intended to guide you through removing the Y-Axis belt. This may be necessary in the
following cases:
• Y-Axis motor needs to be checked for function
• Y-Axis motors needs to be replaced (i.e. broken shaft)
• Adjustment of the pulley on the Y-Axis motor
• Installation of the Y-Axis Upgrade Kit
• Replacement of the Y-Axis Belt
• Tension adjustment in the Y-Axis Belt
> PROCEDURE
1. Remove the top panel
2. Remove the side panel hex nuts & handle screws
CONFIDENTIAL & PROPRIETARY
DO NOT DISTRIBUTE
PAGE 2 OF 3
5246 SW 8
TH
ST, STE 204-A . Coral Gables, FL. 33134 || 786.701.0700 || www.3DChimera.com
3. Loosen the hex screws on the x-axis carriage slightly (1/2 turn)
a. NOTE: Do NOT loosen these screws fully, as there is a mechanism inside of the this
component that can be challenging to re-install
4. Loosen the hex nuts on the side of the x-axis carriage to loosen the belt
CONFIDENTIAL & PROPRIETARY
DO NOT DISTRIBUTE
PAGE 3 OF 3
5246 SW 8
TH
ST, STE 204-A . Coral Gables, FL. 33134 || 786.701.0700 || www.3DChimera.com
5. Manipulate the belt over the y-axis pulley on the motor
/