GB-4 GB-5
DSG Retail Ltd • Maylands Avenue • Hemel Hempstead
Herts • HP2 7TG • England
GB-5
This symbol on the product or in the instructions means that your
electrical and electronic equipment should be disposed at the end
of its life separately from your household waste. There are separate
collection systems for recycling in the EU. For more information,
please contact the local authority or your retailer where you
purchased the product.
Visit Partmaster.co.uk today for the easiest way
to buy electrical spares and accessories. With
over 1 million spares and accessories available
we can deliver direct to your door the very next day. Visit www.partmaster.co.uk
or call 0844 800 3456 (UK customers only) Calls charged at National Rate.
SAFETY FIRST!
Please follow all the safety precautions listed below for safety and to reduce
the risk of injury or electrical shock.
• Read this Instruction Manual carefully to maximise this appliance’s
performance and keep for future reference.
• This appliance is not intended for commercial use or any other uses than its
intended use.
• Always ensure that your power supply voltage matches this appliance’s rating
label.
• Do not use if there are any visible signs of damage to the appliance.
• Do not operate with wet hands or spill water or other liquids on to the
appliance the mains cable or plug.
• Never leave the appliance unattended while in operation.
• Do not place any part of your body near the air inlet and outlet to avoid
personal injury, electric shock or re.
• Avoid obstructing the air inlet and the air outlet.
• Children should be supervised to ensure that they do not play with the
appliance. Do not place the appliance in places that are easy to reach by
children.
• Always unplug the appliance when not in use.
• Do not repair the appliance yourself, but rather consult an authorised expert.
• For safety reasons a broken or damaged mains cable may only be replaced by
the manufacturer or a similarly qualied person.
• Do not operate the appliance in direct sunlight, near heat sources, humid
environments or in places near water or other liquids such as bathrooms,
shower or swimming pool.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instructions
concerning the use of the appliance by a person responsible for their safety.
WARNING: In order to avoid overheating, do not cover the
appliance.
• The heater must not be located immediately below a mains socket. Do not
use the appliance with a programmer, timer or any other device that switches
the appliance on automatically. A re risk exists if the appliance is covered or
positioned incorrectly.
SPECIFICATIONS
Power supply : 220-240V~ 50Hz
Power Consumption : 2000W (High),
1200W (Low),
25W (Fan)
We continually strive to improve our products, specications may change
without prior notice. Ceramic Tower Heater
Instruction Manual
L20CTH10
Congratulations on the purchase of your new Logik
Ceramic Tower Heater.
We recommend that you spend some time reading this
instruction manual in order to fully understand all the
operational features it offers.
Read all the safety instructions carefully before use and keep
this instruction manual for future reference.
(P.N. L20CTH10-001)
GB-1 GB-2 GB-3
OPERATION
The heater is tted with a safety tip over switch, therefore to ensure correct
operation it must be placed on a at and stable surface. The heater must not be
placed on the mains cable as this could cause the tip over switch to operate.
1. Set the Heat Setting Dial to “OFF” position.
2. Insert the mains plug into the mains socket. Set the Heat Setting Dial to
“HIGH & OSC” position and the Thermostat Dial to the “MAX” position to
warm up the room. The Power Indicator will illuminate when the power is
on.
3. Once the room reaches the desired temperature adjust the Heat Setting Dial
to the “LOW” position and rotate the Thermostat Dial anticlockwise until the
heater shuts o. The thermostat will now turn the heater on/o to maintain
the room temperature. During particularly cold weather the low setting may
be insucient to satisfy the thermostat. In this case select the high setting.
For fan only operation, select the “COOL” or “COOL & OSC” position on the
Heat Setting Dial. Set the Thermostat Dial to “MAX” position.
4. The heater can operate in 6 modes, “COOL”, “LOW”, ”HIGH”, “COOL & OSC”,
“LOW & OSC” and “HIGH & OSC”.
• COOL mode : The heater is in fan mode and the heating power is a constant
25W.
• LOW mode : The heater is in economy mode and the heating power is a
constant 1200W.
• HIGH mode : The heater is in maximum power and the heating power is a
constant 2000W.
• COOL & OSC mode : The heater will oscillate while in fan mode.
• LOW & OSC mode : The heater will oscillate while in economy mode.
• HIGH & OSC mode : The heater will oscillate while in maximum power.
• Please allow 5-10 seconds for a setting change.
5. To switch o the heater, adjust the Heat Setting Dial to the “OFF” position.
The fan will continue to operate for 5-10 seconds, and then it will switch off.
OSCILLATION FUNCTION
The heater is equipped with an oscillation feature. If you want to obtain a wider
area of heat circulation, adjust the Heat Setting Dial to “COOL & OSC”, “LOW &
OSC” or “HIGH & OSC” position.
CLEANING
Your heater should be cleaned regularly to stop dirt and dust building up
which will aect its performance. Ensure the air inlet and the air outlet are not
blocked. This can be done with a vacuum cleaner, using the brush
attachment.
HINTS AND TIPS
My heater does not work when I turn it on
1. Check that your heater is plugged in and the power is turned on at the
mains socket.
2. Set the Heat Setting Dial to the highest in ”HIGH” position.
3. Try replacing the BSI or ASTS approved 13 Amp BS1362 fuse in the plug.
4. If the heater still doesn’t work, do not try to repair the heater yourself.
If your radiator’s power is automatically cut o follow the steps below:
1. Unplug your radiator and allow it to cool down.
2. Inspect your radiator.
3. Plug-in the radiator and switch it on again. If it cuts off again, move the
radiator to a better ventilated location.
4. If there is any sign of physical damage (e.g. melting, or burning of the case),
do not attempt to use your radiator. Please leave all maintenance work to
qualied personnel.
Do not override the Tip-over Protective Switch as this may cause a hazard.
Using the unit on a deep pile carpet may activate the tip-over protective
switch.
Ensure you unplug your heater from the mains socket and wait for the
heater to cool down completely before cleaning.
It is normal for the heater to emit some smell and fumes when it is turned
on for the rst time or when turned on after not being used for a long
period of time. This smell will disappear when the heater has been turned
on for a short while.
Always ensure the mains cable can move freely while in oscillation mode to
prevent damage to the heater.
SAFETY PROTECTIVE DEVICES
1. Overheat Protection System
The power to the heater will automatically cut o if the temperature of the
heater exceeds a certain limit. In the event of overheating, the heater will
stop operating. Switch the heater o and allow it to completely cool. The
heater will then resume operating as normal.
2. Tip-over Protective Switch
When you use the heater in an upright position on a at and stable surface,
the tip-over protect switch will be on. In the event the heater is knocked
over, the heater will stop functioning automatically.
Thermostat
Dial
Air outlet
Heat
Setting
Dial
PRODUCT OVERVIEW
CONTROL PANEL
UNPACKING
Remove all packaging from the unit. Retain the packaging. If you dispose of it
please do so according to any local regulations.
The following items are included:
If items are missing or damaged, please contact Partmaster (UK only).
Tel: 0844 800 3456 for assistance.
The Main Unit
Front view Rear view
The Instruction Manual
(P.N.: L20CTH10-001)
Base
Handle
Thermostat
Dial
Max
HIGH
&OSC
HIGH
OFF
LOW
&OSC
COOL
&OSC
COOL
LOW
Min
Temp
Power Indicator
Heat Setting
Dial
Air Inlet
Mains
Cable
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
ORIGO FH9701 User manual
-
Ningbo KPT-2012B User manual
-
Pelonis PTH15A2BGB User manual
-
Kambrook KCE460WHT User manual
-
Pro Breeze PB-H07-UK-FBA User manual
-
Convair CTH04 Owner's manual
-
ProBreeze PB-H07 User manual
-
Sunbeam Bedding HE2300 User manual
-
Matsui MTHE1800 User manual
-
