Gibraltar Building Products 07888 Installation guide

Type
Installation guide
CAUTION! Working above grade is inherently dangerous, be sure that proper fall protection measures
are in place. When working with power tools, gloves and eye protection are absolutely required.
These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional, and to
check with your local building inspector or building permit office for approvals and possible variations that may apply.
#559023
INSTALLATION GUIDELINES
WOODEN SOFFIT VENT #07888
2
1
3
1. From inside the attic locate the area between the soffit
joists where you will be installing the soffit vents. Find the
center and then drill a hole to mark it.
2. Make a 15 in. x 7 in. cardboard template of the rough
opening. Punch an alignment hole in the center.
3. On the outside of your home, center the template over
each hole that you made in Step 1. Trace around the
template. Cut out the template outline with a jigsaw or
reciprocating saw.
4. Install the vent by centering it over the opening and
attaching with four #8 x 1 inch pan-head screws.
Gibraltar Wooden Soffit Vents for surface mounting on wood soffits.
4
6 in
15.24 cm
13 ½ in
34.29 cm
Wood Frame • 1/8 in. Mesh • 64.8 sq. in., N.F.A. • Rough Opening: 13½ in. x 6 in.
  • Page 1 1

Gibraltar Building Products 07888 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI