TWS function (True Wireless Stereo)
If you have two “TS 200” you can activate the TWS function which allows you to
pair two speakers together and obtain Stereo audio reproduction (the speakers will
reproduce the same audio at the same time).
When the mode is active, the functions performed on one speaker (volume
adjustment, track selection, play/pause, off, etc.) will also be reproduced on the other.
Note: in order to use the TWS function, the two speakers must have a maximum
distance of about 3 meters from each other in open spaces.
Activation of the TWS function (how to associate two TS 200s):
Make sure the speakers are not paired with any external Bluetooth devices.
Turn on the two speakers at the same time and select the Bluetooth mode .
Press and hold the "Play / Pause / TWS " button on a speaker to initiate TWS
pairing.
When the speaker emits a sound it means that the pairing is successful and the
TWS function is active.
After making the association, the speakers will automatically re-pair each other
if turned on at the same time.
USB/microSD function
Insert a USB key / microSD card (containing songs in MP3 format) into the
appropriate input and after turning on the speaker, playback will start automatically.
Press the “Play / pause” button to pause / resume playback.
Press the “Next Track” or “Previous Track” button to go to the next / previous track.
Using the number keys on the remote control, you can enter the number of the track
to be played.
You can press the Repeat button on the remote control repeatedly to choose whether
to repeat the same track ( ONE ) or all tracks ( ALL ).
Note:
Compatibility with all USB storage devices on the market cannot be
guaranteed.
External devices that require a rated voltage greater than 5V and a rated current
greater than 500mA are not supported.
If you use a USB extension cable, the connected storage device may not be
recognized or may not work properly.
Use only USB storage devices formatted with the FAT16 / FAT32 file system.
AUX function
To reproduce audio via the AUX input, connect one end of the dedicated cable to the
3.5mm AUX input of the speaker and the other to the external device. Select the
correct source by long pressing the MODE button until “LINE” is selected then start
playback directly from the external device.