500
3
225
Installation Instruction
Item:MU26W19CH
ture off the power.
1 2 3
Wire connection
H
D
C
B
G
F
E
B-Black wire(L) from junction box
C-White wire(N) from junction box
D-Green wire or bare copper
from junction box
F-White wire(N) from fuxture
B-Black wire(L) from fixture
D-Green wire or bare copper from fixture
H-wire connector x 3
Install mounting bracket
Warning:
1.Please wear gloves during the installation.
2.Do not install on ceiling which is damp or with wet limewater.
3.Cut off the electricity before installation in case of
being shocked.
4.Make sure the connected bolt is tightly locked
before getting through the electricity.
5.Do cut off the electricity before washing or repairing,
and use the scour without causticity.
6.Please cut off the electricity and wait until the bulb
gets cooling before replacing the bulb incase of being
burned.
Conect wires
Warning:
1.Please wear gloves during the installation.
2.Do not install on ceiling which is damp or with wet limewater.
3.Cut off the electricity before installation in case of
being shocked.
4.Make sure the connected bolt is tightly locked
before getting through the electricity.
5.Do cut off the electricity before washing or repairing,
and use the scour without causticity.
6.Please cut off the electricity and wait until the bulb
gets cooling before replacing the bulb incase of being
burned.
Warning:
1.Please wear gloves during the installation.
2.Do not install on ceiling which is damp or with wet limewater.
3.Cut off the electricity before installation in case of
being shocked.
4.Make sure the connected bolt is tightly locked
before getting through the electricity.
5.Do cut off the electricity before washing or repairing,
and use the scour without causticity.
6.Please cut off the electricity and wait until the bulb
gets cooling before replacing the bulb incase of being
burned.
Warning:
1.Please wear gloves during the installation.
2.Do not install on ceiling which is damp or with wet limewater.
3.Cut off the electricity before installation in case of
being shocked.
4.Make sure the connected bolt is tightly locked
before getting through the electricity.
5.Do cut off the electricity before washing or repairing,
and use the scour without causticity.
6.Please cut off the electricity and wait until the bulb
gets cooling before replacing the bulb incase of being
burned.
4
Install bulbs.
6
5
Fixed the canopy on the
crossbar with ball nuts.
225
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Transglobe PND-1011 User manual
-
Hampton Bay EHD82620-1L3-BN Operating instructions
-
Bel Air Lighting PL-5842 BGO Installation guide
-
-
-
-
INSTEON Refurbished Remote Control Dimmer Keypad, 6-Button Owner's manual
-
GE 16685 Installation guide
-
-
Filament Design CLI-JB515F-WB Installation guide
