Light
Switch
Quick Start Guide
*Images may dier from your actual product.
1. Power Up Your Switch
Slide the lock to the OPEN position, then hold both
sides of the faceplate and pull it away from the back.
1
Insert two AAA batteries. Make sure the positive and
negative ends of the batteries are facing the correct
direction.
2
2. Set Up Your Switch
1
2
Get the Tapo app from the App Store or Google Play.
Tap the button in the app and select your model.
Follow the in-app instructions to complete setup.
OR
©2021 TP-Link
7106509212 REV1.0.0
2
1
Flip the page over to continue.
3. Wire Your Switch Internal LED & Button
Install your switch following the wiring diagram below.
Make sure you turn o the circuit breaker rst.
The hot / line wire is usually connected to the terminal labelled
“COM” of your old switch.
Dierent Tapo switches have dierent number of Lout wires.
Before installing, servicing or removing the switch, read and follow all safety
precautions including the following:
• Follow all national and local safety regulations and practices. If you are uncertain
or uncomfortable when performing the installation, consult a qualied electrician.
• CAUTION – Risk of Electric Shock – More than one disconnect switch may be
required to de-energize the equipment before servicing. A circuit breaker which
disconnects the Line and Neutral conductor simultaneously is suitable. Ensure
power is o at the circuit breaker before removing or installing any switch. Use a
non-contact voltage tester to ensure the power is o.
• Do not install the Smart Switch with wet hands or when standing on wet or damp
surfaces.
• Keep the device away from water, re, humidity or hot environments
• Do not attempt to disassemble, repair, or modify the device. If you need service,
please contact us.
• Do not use the device where wireless devices are not allowed.
Lin Lout1 Lout2
Neutral
Hot / Line
Lout
Lout
Lin
For technical support, user guides, FAQs,
warranty and more, please visit
www.tapo.com/support/
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/53/EU, 2009/125/EC,
2011/65/EU and (EU)2015/863.
The original EU Declaration of Conformity may be found at
https://www.tapo.com/en/support/ce/
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of the Radio Equipment Regulations 2017.
The original UK Declaration of Conformity may be found at
https://www.tapo.com/support/ukca/
For EU/UK Version:
Operating Frequency / max output power: 868MHz~868.6MHz / 25mW (e.r.p)
Blinking red quickly:
Enter pairing mode.
LED
Solid red for 5s:
Pairing is completed.
Low battery.
Blinking 3 times when
pressing the switch: Press and hold for 5s:
Enter pairing mode.
SYNC/RESET button
-
1
-
2
TP-LINK tp-link Tapo S220 Smart Light Switch User guide
- Type
- User guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
TP-LINK Tapo S210 Smart Light Switch User guide
-
Tapo Tapo H200 User guide
-
TP-LINK Tapo T310 User guide
-
-
TP-LINK tp-link Tapo Hub Operating instructions
-
-
TP-LINK tp-link C420 Smart Wire-Free Security Camera Operating instructions
-
-
-
