2. MAPerformance
  3. MAP EVOX-PSR

MAPerformance MAP EVOX-PSR User manual

  • Hello! I've reviewed the install instructions for the MAP Performance EVOX PSR power steering tank and am ready to assist you with any questions you may have about the device, its installation process, or its features. This document covers the specific steps required for installation, including hose connections and mounting.
  • What tools are needed for installation?
    What is the first step in the installation process?
    What should you do after installing the new reservoir?
MAP EVOX-PSR
Install Instructions
What’s in the box?
1x MAP Billet power steering tank assembled
with all ttings and screen
2x M6 stainless hold-down Allen head ange
bolts.
You will need:
• Needle nose pliers
• 5mm allen wrench
• 10mm socket
Tools needed
Step 1
Remove 2 10mm bolts holding factory power
steering reservoir to the vehicle
Remove upper power steering reservoir hose
from the reservoir. If you own a uid suction
pump now would be the time to remove as
much of the power steering uid in the
reservoir as possible
Step 2
Move reservoir to the side and remove the
lower hose
Step 3
Attach lower hose to MAP evox power steering
reservoir
Step 4
Attach upper hose to MAP evox power steering
reservoir
Step 5
Step 6
Attach MAP evox PSR to the factory reservoir
mounting bracket using uncluded 5mm allen
head bolts
Step 7
Fill PSR to the halfway point in the sightglass.
It is important after install that you start the
car, move the wheel side to side a few times
and recheck the level to ensure the system is
full.
We hope you enjoy your
purchase! Reach out to
us with any issues or
concerns.
1-888-627-3736
@maperformance
suppor[email protected]
www.facebook.com/modernautomotive-
performance/
/