CO Controller Installation
This guide shows how to add the CO Controller,
or handlebar-mounted controller to the handlebar
of your EVELO Electric Bicycle. This applies to
models equipped with the Enviolo Automatiq CVT
shiing system.
EVELO CO Controller Installation 2
Note: There is no digital display on the shier
itself. You will see a flashing LED light as a
power and pairing indicator. Please see the CO
Controller guide for more detailed information.
Step 1: The handlebar-mounted controller
attaches to the right side of the handlebar -
make sure this area is clear of any other installed
accessories.
Step 2: Locate the hex bolt on the bottom of the
handlebar controller.
EVELO CO Controller Installation 3
Step 3: Rotate counter clockwise until it is fully
removed - do not lose this bolt.
Step 4: With this bolt removed, the hinge at the
bottom will open.
Step 5: Place the handlebar controller on the
bicycle handlebar.
EVELO CO Controller Installation 4
Step 6: Insert the hex bolt removed in Step 3
and rotate clockwise until the controller is snug,
but not fully tight.
Step 7: Rotate the controller on the handlebar
and adjust for a comfortable position to press
the buttons while riding. This can be adjusted
again at a later time. Use the hex wrench to fully
tighten the handlebar controller so it does not
move while riding.
Step 8: Your completed installation should
match this photo for optimal operation.
EVELO CO Controller Installation 5
Questions? Get In Touch:
EVELO.COM
First Edition
877-991-7272
contact@evelo.com
/
