Thank you for buying an Angelo Décor Fountain!
We hope you will find these instructions helpful in setting up your fountain. If you need more
information to properly care for your fountain, please DO NOT return the unit to place of purchase.
Please visit our web site, www.angelodecor.com, for assistance and warranty information.
First unpack carton carefully, arranging parts safely in your working area.
Ensure all of the screws on the Adjust the pump to full strength. If splash Twist and lock the pump housing
pre-installed cord seal are tight. is a concern, reduce the flow as needed. in place.
Using the included connection and "Y" joint, connect the tubing from the top Adjust the restrictor as desired to
sections as shown above. increase or decrease water flow.
Connect the tubing to the pump, Twist and lock the top Install the pump
and place inside the housing. to the pump house. access door.
The snuffer (shown above left)
should be used to extinguish the
flame. When not in use, it can be Final assembly should look
hung from the fountain as shown like this
above.
Now simply fill with clean water and plug into a grounded GFCI outlet
We recommend keeping bowl 3/4 full of water to avoid pump burnout.
Your fountain includes an optional
fire feature which should be
installed as shown above.Please
use EXTREME CAUTION when
using this device and follow all
cautions and warnings included
with this device.
/
