18
OPERATING INSTRUCTIONS
Components
A. Appliance shell
B. Blades
C. Hair guides for cutting adjustment
D. ON/OFF switch
E. Light
F. Adapterforpowersupplyunit
G. Adapter plug
H. Small lower plug cable of the applian-
ce
I. Numeric indicator spacer
L. Small cable socket
M. Recharging base
N. Small upper socket of the recharging
support
O. Small lower plug of the appliance
P. Small back plug of the recharging base
Q. Comb
R. Small brush
S. Container for lubricant
T. Cutting spacer from 4 mm to 18 mm
U. Scissors
Z. Hook for spacers
Operation:
As it is easy to use, the appliance is su-
itable to be used at home for beard and
hair trimming.
Its ergonomic and elegant shape makes
it particularly handy.
Wanting to use the spacer (T) add the Z
rails of the device (Fig. 5) and vary the
distance fro
m the blades slide down or
up (Fig. 6) when you reach the required
distance, insert the spacer block (C) by
upward pressure.
Cutting adjustment size
Fig.1 The appliance can be used ei-
ther connected to a mains socket or in
cordless mode, owing to the incorpora-
ted battery. The use of the battery allows
to use it wi- thout length and space re-
quirement limits of the cable.
Battery charge (Fig.2 and Fig.3)
Place the appliance A on the plug N of
the recharging base M. Insert the small
cable socket L on the small back plug P,
then in- sert the plug G of the adapter in
a suitable mains socket, (the E light turns
on) and the battery starts charging.
Use of the appli
ance
with the incorporated battery
Choose the cutting size according to in-
structions of fig. 6. Grab the shell of the
appliance A, push the D switch upwards
(the E light turns on) and it is ready for
cutting. To stop, switch the D switch
downwards.
Use of the appliance
with mains power supply (Fig.4)
Choose the cutting size according to in-
structions of fig. 6.
Insert the small socket L of the small
adapter cable into the small lower socket
L, then insert the plug G of the adapter
in a suitable mains socket, (the E light
turns on).
Grab the shell of the appliance A, push
the D switch upwards (the E light turns
on) and it is
ready for cutting. To stop,
switch the D switch downwards. After
this operation, disconnect the G plug
from the mains power supply.
Start
After choosing the type of power sup-
ply and adjusting the cutting size, to
turn the appliance on, push the D switch
upwards (the E light turns on). To turn it
off, switch the D switch downwards.
Cleaning and maintenance
Never wet the appliance and its electric
components.
For cleaning, use only a cloth, slightly
wet with water or a solution with delicate
soap and dry it thoroughly.
For the cleaning of blades, use the R
brush provided
ATTENTION
The incorpored batter contains substan-
ces, which may damage the environment.
When getting rid of the appliance, ad-
dress to a collection and disposal centre,
in compliance with the environmental re-