7.4V Rechargeable Battery (Included)
USB Charging Cable And
Rechargeable Battery
(Included)
• Controller requires 2 x 1.5v AA
batteries (included)
Charging Method :
1. Turn off the vehilce, unscrew to open the battery
cover and disconnect rechargeable battery pack.
2. Plug USB charger into computer or USB adaptor,
and then connect to rechargeable battery.The USB
charger will light up when it is charging, and it
will turn off when charging is complete.
3. Disconnect USB charging cable and battery. Install
battery to vehicle and replace battery door.
4. Charging time: approximately 2 - 2.5 hours.
Play time: approximately 10-12 mintues.
Attention: Do not charge battery immediately
after each play. Let the battery cool down for a
while.
Slide/Forward
Slide/Forward
Slide/Backward
Slide/Backward
360°Spin
360°Spin
Rollover/Tumbling sliding
Rollover/Tumbling sliding
Pairing Instruction
1. Turn on vehicle first and then turn on transmitter.
2. When the light on the vehicle stops flashing, this means they are matched.
3. If you have more than two vehicles, please pair one by one. When the second vehicle is pairing, please always
keep the first vehicle and transmitter on.
injury.
puddles
/
