Kmart 42921943 User manual

Hello! I've reviewed the user manual for the Kmart Countdown Tree Topper model 42921943. This document provides instructions on how to install batteries, operate the countdown timer, and other important information. I'm ready to answer any questions you might have about this device. Feel free to ask!
What type of batteries does the device use?

How do I start the year digit on the timer?

Can I replace the bulbs if they burn out?

Is this device a toy?

These instructions are for your safety. Please read through

them thoroughly before use and retain for future reference.

Before You Start

This unit is powered by 3 x AAA size batteries (not included).

1. Open the battery door and insert 3 x AAA size batteries correctly. Pay attention to the

polarities (+/-). The unit will not be powered up if you insert batteries in wrong polarity.

2. Always remove the batteries if the unit is not going to be used for an extended period of time.

3. Use only the size and type of battery specified. Batteries shall not be exposed to direct

sunlight or heat source such as fire, oven or the like.

4. When the battery power is low, the unit will not operate. You will need to insert new

batteries. Do not mix new and old batteries.

5. To open the battery door, unscrew the safety screw and remove the battery compartment cover.

Use Instructions

1. Remove all packaging before use and dispose of safely.

2. Use a suitable screwdriver to remove the safety screw and open the battery compartment cover.

3. Insert 3 x AAA size batteries.

4. Replace the battery compartment cover and the safety screw.

5. Move the switch on battery compartment to “ON” position, the light set should now be lit.

6. For indoor use only.

7. For decoration only. This is not a toy.

LED Bulb

This light set is constructed with non-replaceable bulbs.DO NOT attempt to replace any of

the bulbs in the light set.

Keycode: 42921943

Installation and Instructions

BATTERY OPERATED COUNTDOWN

TREE TOPPER

Countdown Setting

1. Press button SET and hold 2-3 seconds to start the year digit, press“+”or

“-” to set year.

2. Press “set” you will enter MONTH interface, press“+”or “-” to set month.

3. Press “set” you will enter DAYS interface, press“+”or “-” to set days.

4. Press “set” you will enter HOURS interface, press“+”or “-” to set hours.

5. Press “set” you will enter MIN interface, press“+”or “-” to set min.

6. Press “set” you will enter SECONDS interface, press“+”or “-” to set seconds.

7. Press “Set” to return to countdown display.

Countdown display → Year → Month→ Day→ Hours→ Minutes→ Seconds→ Countdown display

Month Day Hours Minutes Seconds

Countdown

display

Year

Assembly Diagram