FLASHER
MADE IN THE U.S.A
1
v2.0 | www.feniex.com
OPERATIONAL GUIDE
This manual serves as a guide for the Flasher Controller.
WIRING DIAGRAM
Wiring Instructions:
1. To activate the unit, extend a wire from the 12V+ to a 12V+ activated
post. Extend a wire from 12V- to the ground post of the vehicle’s battery.
2. Select a Mode by applying a 12V+ signal to one of the three
programmable Mode terminals (they will respond to both high signals).
The default pattern will become active.
Note: Mode3 overrides Mode2, and Mode2 overrides Mode1.
3. To program the selected Mode with a different ash pattern, scroll
through the patterns by momentarily connecting the ‘Pattern Changer /
Sync’ terminal to 12V-. The current pattern will turn off and when 12V- is
removed the next pattern will activate.
4. To synchronize more than one Flasher unit, activate the same ash
pattern on all units and connect the ‘Pattern Changer / Sync’ terminals
together.
5. All 4 outputs are rated at 5 amps each. Outputs can be programmed to
provide positive or ground power to each light head. When the green LED
is illuminated, outputs are set to 12V- activation. When the red LED is
illuminated, outputs are set to 12V+ activation.
Label
LEDs
Flashing Red LED: 12V+ Output Control
Flashing Green LED: 12V- Output Control
Output 4
Output 3
Output 2
Output 1
Mode 1
Mode 2
Mode 3
12V -
12V +
Pattern
Changer/
Sync
Switch
Positive
20A Fuse
PositiveGround
12V
Halogen or
LED Light
The drawing above represents a positive output
control
This asher is equipped with 40
patterns.
Patterns 1-20 output positive power
Patterns 21-40 output ground power
Surface Mount
Waterproof Housing