2. Endura
  3. Strike Plate

Endura Strike Plate Operating instructions

  • I've reviewed the instructions for the PanoLock+ Strike Plate assembly and adjustment. This document provides a detailed, step-by-step guide with illustrations for installing and adjusting the strike plate. It covers everything from preparing the mortise to securing the assembly with screws and adjusting for optimal fit. I'm ready to answer your questions about the process.
  • How do I prepare the strike plate mortise?
    How should I orient the reinforcing roller plate?
    How do I adjust the strike plate if needed?
    What screws should I use to secure assembly?
1
PanoLock™ - Strike Plate Assembly & Adjustment
PanoLock+™ Multi-Point Lock Instructions
Strike Plate Assembly & Adjustment
8817 West Market Street
Colfax, NC 27235 | 800.334.2006
www.enduraproducts.com
Ensure strike plate mortise is clear of dust and
debris.
STEP 1
Place reinforcing roller plate into frame mortise.
Orient tabs toward edge of frame. Align end of tabs
with edge of frame.
STEP 2
Place strike plate on top of reinforcing roller plate.
Orient curved lip towards frame edge.
STEP 3
Secure assembly with two short screws provided,
through strike plate.
STEP 4
Ta b
2U-INSTR-STRIKES
Last Updated: 11/17/2023
2
PanoLock™ - Strike Plate Assembly & Adjustment
If adjustment of the strike is required to either
loosen or tighten fit with weatherstrip, first partially
loosen short screws.
STEP 5
While holding top strike plate in position, move
lower reinforcing plate assembly to the left
or right – as needed to loosen or tighten door
panel fit.
STEP 6
Retighten short screws to secure strike plate
assembly at its adjusted position.
STEP 7
Place two long screws provided, through holes in
reinforcing roller plate.
STEP 8
/