Human Touch Acessory Table User manual

Installing your Perfect Chair

accessory table.

Parts

ENG

Locate the two front bolts/washers underneath the right-hand armrest (Fig.1).

Using the 3/16-inch Allen wrench remove the two bolts and washers.

Discard the bolts and washers.

Align the two holes in the accessory table mounting arm with the two holes on front the right-hand armrest

(left by the bolts you just removed).

Install a washer onto each new bolt, then install and hand-tighten both bolts. IMPORTANT: Be sure you use

the new bolts, as they are longer than the bolts you removed from the armrest.

Using the 3/16-inch Allen wrench, tighten both bolts to secure the accessory table firmly to the armrest.

Note: The Perfect Chair accessory table fits all models except the PC-085 and PC-086. The 3/16-inch Allen wrench and two

bolts/washers required for installation are included (taped to the inside of the box end panel). No other tools are required.

Accessory table Bolt (2) Washer (2) Allen wrench

(Fig.1)

Accessory Table

3/16” Allen Key

Bolts and Washers

, LLC.

PC-AccessoryTable-A0

Questions? Call Human Touch Customer Service at 800-355-2762.

Page is loading ...

Download PDF