CareFusion
San Diego, CA
carefusion.com/alaris
© 2010 CareFusion Corporation or one of its subsidiaries. All rights reserved. Alaris and SmartSite are trademarks
or registered trademarks of CareFusion Corporation or one of its subsidiaries. IV1942 (0910/1000)
SmartSite
®
vented vial access
device with 0.2 hydrophobic
air-venting filter
1. Prepare vial
• Swab the vial with 70%
isopropyl alcohol and allow
it to dry
2. Attach vial access device
• Remove protective sheath from spike
• Hold the body of the needle-free valve and insert
the vial access device into the center of the vial
3. Prepare valve
• Swab the top of the needle-free valve with
70% isopropyl alcohol and allow it to dry
4. Reconstitute and/or withdraw fluid
• Connect the syringe to the needle-free valve
• Inject desired amount of diluent into the vial if needed
• Invert vial and withdraw desired amount of solution
1
2
3
4
b4a
Important tips:
• Do not inject fluid when the vial is inverted
• To clear filter surface, aspirate with empty syringe
to create negative pressure
• Do not hold the vent when inserting the spike into
the vial
• Do not use vial access device to access more than
one vial
• Always swab the SmartSite needle-free valve prior
to accessing
• Replace device every 96 hours or after 20 uses, whichever
occurs first
Model 10012392-0500
/
