Minka Group 8766-166 User manual

Minka Group
Brand
Minka Group
Model
8766-166
Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
For Model 8765, 8766
READ AND SAVE THESE INSTRUCTIONS
WARNI N G! SH UT PO WER OFF AT F US E O R C I RC UIT BREAKE R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
Fig. 2
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the circuit breaker and remove the
old fixture.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Carefully remove screws (B) to separate top cover (A)
from fixture body (C).
CONNECTING THE WIRES (Fig. 2)
4. While supporting the fixture, connect the electrical wires
as shown in figure 2. If your post has a ground wire
(green or bare copper), connect the fixture ground wire
to it. If not, consult your electrician for proper grounding.
After the wires are connected, tuck them carefully inside
the post (A).
COMPLETING THE INSTALLATION (Fig.1)
5. Align the fixture (C) to post (E), and secure with
mounting screws (D).
6. Install the bulb(s) (8765 3*60W E12) (8766 1*100W A19)
in accordance with the fixtures specifications. DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
7. Re-attached top cover (A) to fixture body (C) with screws
(B).
Your installation is now complete. Return power to the
junction box and test the fixture
FIXTURE
WIRES
Black or
Smooth
HOUS
E
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUS
E
WIRES
White
(Neutra
l)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUS
E
WIRES
Green
or
Bare
Copper
(Groun
d)
  • Page 1 1

Minka Group 8766-166 User manual

Minka Group
Brand
Minka Group
Model
8766-166
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents