USB Charger Wall Plates,
Standard or Decor, 2.4A,
AWPUC2-G-2.4A, AWPUC2-D-2.4A
www.asi-ez.com
Automation Systems Interconnect, Inc.
n
P.O. Box 1340, Mechanicsburg, PA 17055
n
Phone: (717) 249-5581 or (877) 650-5160
ASI
Automation Systems Interconnect, Inc
Innovative Interconnect and Interface Solutions
The USB Charger Wall Plates are easy to install, wireless,
2.4A, 5V charging capacity with 2 charging ports. They are
designed to be used with standard duplex receptacles and
decor duplex receptacles. Installation is as simple as
removing the existing wall plate and replacing it with the
wall plate charger using the same screw. The 2.4A charging
capacity makes them ideal for charging any USB device
from mobile phones to tablets.
• EZ Install
• No Wiring
• White or Ivory
• Available in Standard or Decor
• NOT for use with GFCI Receptacles
Installing the USB charger wall plate is a quick process. There are a few instances when simple adjustments
are required for successful contact between the metal tabs of the USB charger wall plate and the metal screws
on the AC outlet. In any of these instances, it is important to turn off power to the outlet before making these
adjustments.
1. If USB charger wall plate does not easily slide into place, the screws on the sides of the AC outlet may be
extended too far. Simply tighten the screws and reinsert the USB charger wall plate.
2. If the USB charger wall plate does not make contact with the screws on the sides of the AC outlet, simply
loosen the screws so they are extended and reinsert USB charger wall plate.
3. If there is electrical tape surrounding the ac outlet screws, it may be best to contact an electrician before
proceeding.
Turn the power back on when adjustment is complete. A green LED indicator light will let you know when
proper contact has been made.
Specications:
Input Voltage: 120Vac, 60 Hz
Input Current: 0.5A Max
Output Voltage: 5Vdc
Output Current: 2.4A Total
USB Ports: Two
Dimensions (H x W x D): 180 x 90 x 30 mm
/
