Toro Chuted Blade, Vibratory Plows for Compact Utility Loaders Installation guide

Brand: Toro

Model: Chuted Blade, Vibratory Plows for Compact Utility Loaders

Type: Installation guide

W 2005 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Chuted Blade

for Vibratory Plows

Part No. 104-0640

Form No. 3353-866 Rev A

Installation Instructions

Installing the Blade

1. Raise the plow about 3 feet (1 m) off of the ground.

2. Stop the engine and remove the key.

3. Remove the two click pins from the clevis pins in the

blade bracket, then remove the clevis pins (Fig. 1).

4. Slide the blade into the blade bracket and secure it at

the desired depth (a change in mounting holes will

change the depth by 3 in. (7.6 cm)), using the clevis

pins and click pins removed previously (Fig. 1).

m–4910

Figure 1

1. Click pin

2. Clevis pin

3. Blade

Installing Cable

1. Remove the large wingnut and bolt from the top of the

blade (Fig. 2).

2. Pull the cable guide out of the blade (Fig. 2).

3. Place the cable to be installed in the chute (Fig. 2).

4. Install the cable guide and secure it with the wingnut

and bolt (Fig. 2).

m–4908

Figure 2

1. Bolt

2. Large wingnut

3. Blade

4. Cable guide

5. Chute

5. Secure the end of the cable coming out of the bottom

of the blade to a post or have someone hold it.

6. Begin plowing while routing the cable over the plow

and into the blade (Fig. 3).

m–4909

Figure 3

7. When finished, remove the plow from the soil and

remove the cable from the blade.

Cleaning the Blade

After each use, clean the blade as follows:

1. Remove the large wingnut and bolt from the top of the

blade (Fig. 2).

2. Pull the cable guide out of the blade (Fig. 2).

3. Wash out the inside of the chute with water to remove

any dirt.

4. Wash the rest of the blade.

5. Install the cable guide and secure it with the wingnut

and bolt (Fig. 2).

Toro Chuted Blade, Vibratory Plows for Compact Utility Loaders Installation guide

Toro Chuted Blade, Vibratory Plows for Compact Utility Loaders Installation guide

Toro Chuted Blade, Vibratory Plows for Compact Utility Loaders Installation guide

Related papers

Other documents