Bel Air Lighting PL-5041 BK User manual

Type
User manual
ITEM NO: PL-5041
ITEM NO: PL-5041
CAUTION:This lamp is partially assembled in the factory
by qualified craftsmen.Some assembly is required
before use.Please follow the assembly instructions carefully.
IMPORTANT: Before you start,
NEVER
attempt any work without shutting off the electricity until the
work is done.
a) Go to the main fuse, or circuit breaker, box in your home. Place the main power switch
in the "OFF" position.
b) Unscrew the fuse(s), or switch "OFF" the circuit breaker switch(s), that control the power to
the fixture or room that you are working on.
c) Place the wall switch in the "OFF" position. If the fixture to be replaced has a switch or pull chain,
place those in the "OFF" position.
PREPARATION
PREPARATION
1. Shut off main power at the circuit breaker or fuse panel before removing old fixture.
2. Remove old fixture Disconnect wiring.
FIXTURE INSTALLATION
1. Fix the support screws(B) with hex nuts(F)
onto the mountin
g
p
late
(
H
)
2. Attach mounting plate(H) to junction box using
mounting screws(C).
3. Strip 3/4” of insulation from wire ends. Twist
stripped ends together with pliers black to
black(power) white to white (neutral). Snip ends.
Attach copper wire to ground wire and attach to
green ground screw
4. Attach wire nuts(A). Tape nuts and wires together.
5. Attach fixture(I) to outlet box by aligning support
screws(B) with holes in fixture(I), secure with nuts(D).
GU24-base bulb or less.
7. Place the cover assembly(L) under the shade lid.
Align the screws to the holes on the lid. Fit the
waterproof rubber washers(J) and screw
on the nuts(D).
CLEANING:
CLEANING:
Use only soft cloth to
dust and clean fixture. Never use
chemicals or abrasive cleaners as it may damage finish.
6. Install light bulb(K). Use fluorescent 1-26
Product assembly must be carried out by qualified personnel only.
Product assembly must be carried out by qualified personnel only.
PRINTED IN CHINA
AT NIGHT.
AT NIGHT.
2 year limited warranty
2 year limited warranty
ACTIVATE THE BULB SHUTOFF AUTOMATIC DAYLIGHT
ACTIVATE THE BULB SHUTOFF AUTOMATIC DAYLIGHT
PHOTOCELL FEATURE:
PHOTOCELL FEATURE:
AND REACTIVATION OF THIS SHUTOFF AUTOMATIC
AND REACTIVATION OF THIS SHUTOFF AUTOMATIC
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
  • Page 1 1

Bel Air Lighting PL-5041 BK User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI