Kichler Lighting 15205AZT is a versatile lighting fixture that can be mounted using a variety of accessories. It can be used with a 1/2 NPSM threaded stem (sold separately) or with parallel cord. The fixture can be connected to either black or red supply wires, and the white supply wire should be connected to the white wire on the fixture. The fixture comes with a diffuser and louvres, which can be assembled to create a variety of lighting effects. The diffuser has a bead around the edge that should be at the top of the fixture when it is installed. The louvres should be slid over the diffuser so that the smaller diameter end is nearest the fixture roof. The louvres will fit together when the tabs are lined up with the grooves on the adjoining louvre. The diffuser assembly should then be threaded into the lamped fixture base.
Kichler Lighting 15205AZT is a versatile lighting fixture that can be mounted using a variety of accessories. It can be used with a 1/2 NPSM threaded stem (sold separately) or with parallel cord. The fixture can be connected to either black or red supply wires, and the white supply wire should be connected to the white wire on the fixture. The fixture comes with a diffuser and louvres, which can be assembled to create a variety of lighting effects. The diffuser has a bead around the edge that should be at the top of the fixture when it is installed. The louvres should be slid over the diffuser so that the smaller diameter end is nearest the fixture roof. The louvres will fit together when the tabs are lined up with the grooves on the adjoining louvre. The diffuser assembly should then be threaded into the lamped fixture base.
Kichler Lighting 15205AZT is a versatile lighting fixture that can be mounted using a variety of accessories. It can be used with a 1/2 NPSM threaded stem (sold separately) or with parallel cord. The fixture can be connected to either black or red supply wires, and the white supply wire should be connected to the white wire on the fixture. The fixture comes with a diffuser and louvres, which can be assembled to create a variety of lighting effects. The diffuser has a bead around the edge that should be at the top of the fixture when it is installed. The louvres should be slid over the diffuser so that the smaller diameter end is nearest the fixture roof. The louvres will fit together when the tabs are lined up with the grooves on the adjoining louvre. The diffuser assembly should then be threaded into the lamped fixture base.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI