Graco 308654D Owner's manual

Graco
Brand
Graco
Model
308654D
Category
Paint Sprayer
Type
Owner's manual

This manual is also suitable for

Graco 308654D FTx Spray Gun Swivel Replacement Kit 238817

This kit provides the necessary parts to replace the swivel on your Graco FTx spray gun. The swivel allows the gun to be rotated for easier use in different positions. The kit includes the swivel, guard retainer, and cushion o-ring.

Key Features:

  • Replaces the swivel on your Graco FTx spray gun
  • Allows the gun to be rotated for easier use in different positions
  • Includes the swivel, guard retainer, and cushion o-ring

Possible Use Cases:

  • Replacing a damaged or worn swivel on your Graco FTx spray gun
  • Upgrading your spray gun with a new swivel for improved performance and ease of use

Graco 308654D FTx Spray Gun Swivel Replacement Kit 238817

This kit provides the necessary parts to replace the swivel on your Graco FTx spray gun. The swivel allows the gun to be rotated for easier use in different positions. The kit includes the swivel, guard retainer, and cushion o-ring.

Key Features:

  • Replaces the swivel on your Graco FTx spray gun
  • Allows the gun to be rotated for easier use in different positions
  • Includes the swivel, guard retainer, and cushion o-ring

Possible Use Cases:

  • Replacing a damaged or worn swivel on your Graco FTx spray gun
  • Upgrading your spray gun with a new swivel for improved performance and ease of use
308654DINSTRUCTIONS-PARTS LIST
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
FTx Spray Gun
Swivel Replacement Kit 238817
GENERAL REPAIR INFORMATION
WARNING
INJECTION HAZARD
The system pressure must be manually
relieved to prevent the system from
starting or spraying accidentally. Fluid
under high pressure can be injected through the
skin and cause serious injury. To reduce the risk of
an injury from injection, splashing fluid, or moving
parts, follow the Pressure Relief Procedure
whenever you:
D are instructed to relieve the pressure,
D stop spraying,
D check or service any of the system equipment,
D or install or clean the spray tip.
Pressure Relief Procedure
1. Engage the gun safety latch.
2. Turn the ON/OFF switch to OFF.
3. Unplug the power supply cord.
4. Disengage the gun safety latch. Hold a metal part
of the gun firmly to a grounded metal pail. Trigger
the gun to relieve pressure.
5. Engage the gun safety latch.
6. Open the pressure drain valve. Leave the pressure
drain valve open until ready to spray again.
If you suspect that the spray tip or hose is completely
clogged, or that pressure has not been fully relieved
after following the steps above, VERY SLOWLY loos-
en the tip guard retaining nut or hose end coupling to
relieve pressure gradually, then loosen completely.
Now clear the tip or hose obstruction.
Test your repair before regular operation of the
sprayer to be sure the problem is corrected.
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
ECOPYRIGHT 1996, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
2 308654
Service
Replace Swivel
Disassembly
1. Follow Pressure Relief Procedure on page 1.
2. Push up on trigger guard (12) and swing trigger
guard away from trigger (5).
3. Unscrew gun handle (6) from housing (26).
Remove filter and clean in compatible solvent.
4. Remove swivel (15), guard retainer (42) and
cushion o–ring (43) on other side of (42).
5. Save guard retainer and cushion o–ring.
Reassembly
1. Clean internal thread of handle (6).
2. Install guard retainer (42), cushion o–ring (43) and
swivel (15).
3. Apply anaerobic sealant (included in Swivel Kit
238817) to external thread of swivel (15) that
connects to swivel handle (6).
4. Install swivel (15) into handle (6). Torque swivel to
250 in–lb.
5. Engage trigger guard (12) to retainer guard (42).
6
12
42
43
15
05968B
Graco headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
PRINTED IN U.S.A. 308654 03/1996, Rev 07/2005
  • Page 1 1
  • Page 2 2

Graco 308654D Owner's manual

Graco
Brand
Graco
Model
308654D
Category
Paint Sprayer
Type
Owner's manual
This manual is also suitable for

Graco 308654D FTx Spray Gun Swivel Replacement Kit 238817

This kit provides the necessary parts to replace the swivel on your Graco FTx spray gun. The swivel allows the gun to be rotated for easier use in different positions. The kit includes the swivel, guard retainer, and cushion o-ring.

Key Features:

  • Replaces the swivel on your Graco FTx spray gun
  • Allows the gun to be rotated for easier use in different positions
  • Includes the swivel, guard retainer, and cushion o-ring

Possible Use Cases:

  • Replacing a damaged or worn swivel on your Graco FTx spray gun
  • Upgrading your spray gun with a new swivel for improved performance and ease of use
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents