Progress PEM6000E User manual

benutzerinformation

user manual

notice d'utilisation

gebruiksaanwijzing

Kochmulde

Electric Solid Hob

Table de cuisson électrique

Elektrische vaste kookplaat

PEM6000E

Page is loading ...

Contents

Safety instructions 8

Description of the Appliance 9

Operating the hob 9

Tips on Cooking and Frying 9

Cleaning and Care 10

What to do if … 10

Disposal 10

Installation Instructions 11

Service 12

Subject to change without notice

Safety instructions

Please comply with these instructions. If

you do not, any damage resulting is not

covered by the warranty.

Correct use

• This appliance is not intended for use by

children or other persons whose physical,

sensory or mental capabilities or lack of

experience and knowledge prevents them

from using the appliance safely without su-

pervision or instruction by a responsible

person to ensure that they can use the ap-

pliance safely.

• Do not leave the appliance unattended

during operation.

• This appliance should be used only for

normal domestic cooking and frying of

food.

• The appliance must not be used as a work

surface or as a storage surface.

• Additions or modifications to the appliance

are not permitted.

• Do not place or store flammable liquids,

highly inflammable materials or fusible ob-

jects (e.g. plastic film, plastic, aluminium)

on or near the appliance.

Children’s safety

• Small children must be kept away from the

appliance.

• Only let bigger children work on the appli-

ance under supervision.

General safety

• The appliance may only be installed and

connected by trained, registered service

engineers .

• Built-in appliances may only be used after

they have built in to suitable built-in units

and work surfaces that meet standards.

• If there is a fault with the appliance, all hot-

plates must be switched off and the appli-

ance must be disconnected from the

mains supply to avoid any possible electric

shock.

• Repairs to the appliance must only be car-

ried out by trained, registered service en-

gineers.

Safety during use

• There is the risk of burns from the appli-

ance if used carelessly.

• Cables from electrical appliances must not

touch the hot surface of the appliance or

hot cookware.

• Overheated fats and oils can ignite quickly.

When cooking with fat or oil (e.g when fry-

ing chips) do not leave the appliance un-

attended.

• Switch the hotplates off after each use.

Safety when cleaning

• For cleaning, the appliance must be

switched off and cooled down.

• For safety reasons, the cleaning of the ap-

pliance with steam jet or high-pressure

cleaning equipment is not permitted.

How to avoid damage to the appliance

• Do not allow acid liquids such as vinegar,

lemon juice or limescale removing agents

to touch the hob, as otherwise this will

cause matt patches.

• Do not place wet pan lids on the hotplates

and do not allow hot pans to cool on the

hotplates. Otherwise condensation and

rust can form.

• Do not use the hotplates with empty cook-

ware or without cookware.

8 progress

Description of the Appliance

1 2

4 3

145 mm

180 mm

1. Solid Hotplate 1000W

2. Quick Hotplate 2000W

3. Solid Hotplate 1000W

4. Quick Hotplate 2000W

Operating the hob

You operate the appliance with the com-

bination appliance’s ring switches. The

operation and the function of the ring

switches is described in the Operating

Instructions for the combination appli-

ance.

Warning! The hotplates still remain hot

for a time even after being switched off.

There is a risk of burns. Let the hotplates

cool down.

Tips on Cooking and Frying

Information on acrylamides

According to the latest scientific knowl-

edge, intensive browning of food, espe-

cially in products containing starch, can

constitute a health risk due to acryla-

mides. Therefore we recommend cook-

ing at the lowest possible temperatures

and not browning foods too much.

Cookware

You can recognise good cookware from the

bottoms of the pans. The bottom should be

as thick and flat as possible.

Energy saving

Always place cookware on the cooking

zone before it is switched on.

If possible, always place lids on the

pans.

Switch cooking zones off before the end

of the cooking time, to take advantage

of residual heat.

Bottom of pans and cooking zones

should be the same size.

progress 9

Cleaning and Care

Warning! Risk of burns from residual

heat. Let the appliance cool down.

Cleaning the appliance after each use

1. Wipe the appliance with a damp cloth

and a little washing up liquid.

2. Rub the appliance dry using a clean cloth.

Removing deposits

1. Remove heavy deposits from the hot-

plates using fine scouring powder or a

scouring pad.

2. Wipe off residues with a damp cloth.

3. Then heat the hotplate to a low temper-

ature and leave to dry.

4. To maintain the hotplates, rub in a little

sewing machine oil now and again and

then polish off with absorbent paper.

Warning! Do not clean the stainless

steel edge of the hob with scouring

powder or a scouring pad as this will

leave scratches! For stainless steel hobs

only use suitable stainless steel cleaning

and maintenance products. Please the

manufacturer’s instructions.

The stainless steel edge of the plate can

be slightly discoloured as a result of ther-

mal load. This process is caused by the

physical properties.

What to do if …

Problem Possible cause Remedy

The hotplates are not function-

ing

The combination appliance is

not switched on

Switch on the appliance.

The desired heat setting is not

set.

Set the heat setting.

The fuse in the house’s electrical

wiring (fuse box) has been trip-

ped.

Check the fuse. If the fuses trip

a number of times, please call an

authorized electrician.

If you are unable to remedy the problem

by following the above suggestions,

please contact your dealer or the Cus-

tomer Care Department.

Warning! Repairs to the appliance are

only to be carried out by qualified service

engineers. Considerable danger to the

user may result from improper repairs.

If the appliance has been wrongly oper-

ated, the visit from the customer service

technician or dealer may not take place

free of charge, even during the warranty

period.

Disposal

The symbol on the product or on its

packaging indicates that this product may

not be treated as household waste. Instead

it should be taken to the appropriate

collection point for the recycling of electrical

and electronic equipment. By ensuring this

product is disposed of correctly, you will help

prevent potential negative consequences for

the environment and human health, which

could otherwise be caused by inappropriate

waste handling of this product. For more

detailed information about recycling of this

product, please contact your local council,

your household waste disposal service or the

shop where you purchased the product.

10 progress

Installation Instructions

Safety instructions

Warning! This must be read!

The laws, ordinances, directives and stand-

ards in force in the country of use are to be

followed (safety regulations, proper recycling

in accordance with the regulations, etc.) In-

stallation may only be carried out by a quali-

fied electrician. The minimum distances to

other appliances and units are to be ob-

served. Anti-shock protection must be pro-

vided by the installation, for example drawers

may only be installed with a protective floor

directly underneath the appliance. The cut

surfaces of the worktop are to be protected

against moisture using a suitable sealant.

The sealant seals the appliance to the work

top with no gap. When building in, protect the

underside of the appliance from steam and

moisture, e.g. from a dishwasher or oven.

Avoid installing the appliance next to doors

and under windows. Otherwise hot cook-

ware may be knocked off the rings when

doors and windows are opened.

Warning! Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of

voltage.

• Follow connection schematic.

• Observe electrical safety rules.

• Ensure anti-shock protection by in-

stalling correctly.

• The appliance must be connected to

the electrical supply by a qualified

electrician.

Warning! Risk of injury from electrical

current.

• Loose and inappropriate plug and

socket connections can make the ter-

minal overheat.

• Have the clamping connections cor-

rectly installed by a qualified electri-

cian.

• Use strain relief clamp on cable.

• In the event of single-phase or two-

phase connection, the appropriate

mains cable of type H05BB-F Tmax

90°C (or higher) must be used.

• If this appliance’s mains cable is dam-

aged, it must be replaced by a special

cable (type H05BB-F Tmax 90°C; or

higher). The latter is available from the

Customer Care Department

A device must be provided in the electrical

installation which allows the appliance to be

disconnected from the mains at all poles with

a contact opening width of at least 3 mm.

Suitable isolation devices include line pro-

tecting cut-outs, fuses (screw type fuses are

to be removed from the holder), earth leak-

age trips and contractors.

Assembly

min.

50mm

min. 500mm

progress 11

MEE0004

PEM 6000 E

6,0 kW

949 592 995

230 V 50 Hz

PROGRESS

Service

In the event of technical faults, please first

check whether you can remedy the problem

yourself with the help of the operating in-

structions (section “What to do if…”).

If you were not able to remedy the problem

yourself, please contact the Customer Care

Department or one of our service partners.

In order to be able to assist you quickly, we

require the following information:

– Model description

– Product number (PNC)

– Serial number

(S No. - see rating plate)

–Type of fault

– Any error messages displayed by

the appliance

– three digit letter-number combination

for glass ceramic

12 progress

Page is loading ...

Progress PEM6000E User manual

Progress PEM6000E User manual

in other languages

Related papers

Other documents