Carver 35ss Assembly Instruction

Brand
Carver
Model
35ss
Type
Assembly Instruction
Page 1 of 4
35 Super Sport Setup Part Number 9991903 03/07
35 Super Sport Setup
1. Install the props and drain plug.
2. Remove tape and clean the areas where
the bridge will set. Check for voids
along the top of the windows.
3. On bridge remove starboard box out
under switch panel and take off port
aft access panel.
4. Apply sealant (732 white silicone
# 8101201) around deck bolts.
Apply sealant (white sikaflex
# 8105901) around deck where
bridge will set, including the top
of patio door.
5. ere are four lifting eyes points for
bridge.
Page 2 of 4
35 Super Sport Setup Part Number 9991903 03/07
35 Super Sport Setup
6. Position bridge over boat.
Run appropriate wires thru aft
starboard corner; and appropriate
wires thru aft port corner.
7. Set bridge in place, making sure that
no wires get caught or pinched off.
Make sure the bridge is pushed all the
way forward.
8. With the bridge in place, bolt it down.
a. ree bolts under forward of bridge.
b. One bolt on each side aft.
9. Before installation of electronics arch
remove screws from side wings on
bridge windshield to allow installation
of arch.
Clean around the studs where
electronics arch sets.
Put silicone around the studs and
hole opening where wires and
cable come thru.
Place Tuff Gel on studs. Lift arch
from cockpit and set on studs.
Put plate, flat washer, lock washer
and nut on stud and tighten arch
down.
10. Reinstall windshield to bridge
and arch.
Put silicone in screw holes.
Cosmetically seal around windshield
and arch base.
11. Connect the arch wires to the
corresponding bridge wires and tie
them up.
12. Install anchor light to top of arch.
Remember to seal hole where
wire comes thru and to use Tuff Gel
on fasteners.
Cosmetically seal around base of
anchor light.
Page 3 of 4
35 Super Sport Setup Part Number 9991903 03/07
35 Super Sport Setup
13. Connect wires below starboard switch
panel and aft port corner of bridge.
Run shift, throttle cable
and steering lines to helm and
hook up.
After testing, screw starboard box
in and cosmetically seal around it.
Reinstall port aft access plate.
14. Remove forward lifting eyes and install
bridge navigation lights on the bridge.
Apply silicone sealant around wire and
screws and fill hole.
15. Install the helm and companion seats
onto their bases.
Also install helm forward bench seat.
16. Under forward of bridge install three
white panels. Remember to use
silicone on screws.
Page 4 of 4
35 Super Sport Setup Part Number 9991903 03/07
35 Super Sport Setup
17. Cosmetically seal aft bridge to cabin
top seam.
18. Install white drip cap above patio
door. Remember to use silicone on
screws and cosmetically around cap.
19. Install canvas bow set and canvas
(if ordered).
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Carver 35ss Assembly Instruction

Brand
Carver
Model
35ss
Type
Assembly Instruction
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents